Huffy Universal Elevator Mount manual Height Adjustment

Page 2

￿WARNING

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT￿ IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

Owner must ensure that all players know and￿ follow these rules for safe operation of the unit.

See instruction manual for proper installation and ￿ maintenance.￿

Use caution when performing dunk type activities on this unit.￿

Do not hang from any part of unit, including backboard, ￿ ￿support braces, rim or net.￿

Keep pole top covered with cap at all times.￿

Do not slide, climb, shake or play on pole.￿

Keep organic material away from pole base. Grass, litter, etc. ￿ could cause corrosion and/or deterioration.￿

Check pole system for signs of corrosion (rust, pitting, ￿ chipping) and repaint with exterior enamel paint. If ￿ rust has penetrated through steel anywhere, replace pole ￿ immediately.￿

Check unit before each use for loose hardware, excessive ￿ wear and signs of corrosion and repair before using.￿

Check unit before each use for stability.￿

During play, use extreme caution to keep player's face away ￿ from the backboard, rim or net. Serious injury could occur if￿ ￿teeth/face come in contact with backboard, rim or net.￿

When adjusting height, keep hands and fingers away from ￿ moving parts. Do not allow children to adjust unit.￿

During play, do not wear jewelry (rings, watches, necklaces, ￿ etc.) Objects may entangle in net.￿

￿

￿ HEIGHT ￿

ADJUSTMENT

Insert end of broom handle ￿

 

or wooden dowel 3/4"-7/8"￿

IMPORTANT!￿

(19-22mm) diameter ￿

into release lever.

Push up, ￿

Push up, pivot outward ￿

pivot inward￿

and lower ￿

to raise and lower

to lock

In the U.S.: 1-800-558-5234 and Canada Only: 1-800-284-8339

206117 5/97

P/N 211125A 10/01

2

Image 2
Contents Safety Instructions IMPORTANT! Have questions...don’t go back to the storeHeight Adjustment Channel 2 and position angle brackets Install angle brackets 6 and 7 to lower holes onRoof Mounting Horizontally on roof. Tighten until snug 10/01 211125A106 10/01 211125A Not IncludedHeight Adjustment Procedure, elevator assembly is For Pole Mounting onlyFlat Surface Mounting Regulation RIM Height Parts List Hardware Identifier