6. IMPORTANT! Test fit bolts into holes of brackets (8) and carefully rock them in a circular motion to ream out paint from holes if necessary.
8
7. IMPORTANT! Finger tighten nuts and bolts until instructed to fully tighten later.
8. Fit spacer (11) into pawl (13) and fit pin of pawl through end slot of release
lever (12). | 15 |
9
16
13
11
10
14
12
9. IMPORTANT! Bolt (18) must be inserted through tube (17), spacer (19), support bracket (10), board bracket (8), release lever (12), wave washer (20), and then ratchet (21). Fully tighten all nuts and bolts after assembly.
10. Use pliers to stretch spring (23) into position.
8 | 21 |
|
|
| 20 | 22 |
|
|
|
| |
| 19 |
| 17 |
|
|
| |
19 |
|
|
|
| 12 |
|
|
| 10 |
|
|
| 18 |
|
|
17 |
|
|
|
| 23 | 10. |
|
| 5 | 10/01 | P/N 211125A |
|
|