SET UP INSTRUCTIONS
Place the INSTRIDE
PRO stepper in the area where it will be used. It is recommended that the INSTRIDE PRO stepper be placed on an equipment mat. The max. operation dimensions of INSTRIDE
PRO stepper is approximately 17 3/8" long x 11 3/4" tall x 12 3/8" wide. (These dimensions may vary up to one inch.) An area 6 feet wide x 6 feet long is required for safe operation of the INSTRIDE PRO stepper. Make sure that adequate space is available for access to and passage around the INSTRIDE
PRO stepper.
LEVELING: Make sure the INSTRIDE
PRO stepper is set solidly on the floor with no rocking. MOVING: Grasp the Front and Rear Stabilizers to move the INSTRIDE PRO stepper. Do not use the
Pedal Arms to move the INSTRIDE
PRO stepper. The Pedal Arms will move and the SHOCK(6) may pinch your hand or fingers.
FUNCTION INSPECTION
NOTE: Always make sure that the CABLE(9) is properly seated in the groove on the PULLEY(8) before using the INSTRIDE PRO stepper.
Visually inspect the INSTRIDE
PRO stepper to verify that assembly is as shown in the above illustrations. Check the function of the INSTRIDE PRO stepper. Stand on the foot pedals and slowly move your highest foot downward and follow the natural path of the machine. The Shocks should provides resistance for your workout.
STORAGE
1. To store the INSTRIDE PRO stepper simply keep it in a clean dry place.
2. The minimum dimesions of INSTRIDE PRO stepper is approximately 17 3/8" long x 8 1/4" tall x 12 3/8" wide. These dimensions will vary. Please measure your INSTRIDE PRO stepper if exact dimensions are needed.
3. Grasp the Front and Rear Frame to move the INSTRIDE PRO stepper. Do not use the Pedal Arms to move the INSTRIDE PRO stepper.
4. To avoid damage to the electronics, remove the battery before storing the INSTRIDE PRO stepper for one year or more.
MAINTENANCE
The safety and integrity designed into the INSTRIDE PRO stepper can only be maintained when the INSTRIDE PRO stepper is regularly examined for damage and wear. Special attention should be given to the following:
1.Inspect the RESISTANCE TUBES(32, 33) for nicks and cuts. Replace damaged RESISTANCE TUBES (32, 33).
2.Verify that the SHOCKS(6) provides resistance by pushing down on the foot pedals.
3.SHOCKS(6) on steppers get HOT during use. To avoid burns, do not touch the SHOCKS(6) until they have time to cool.
4.Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
5.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. | Worn or damaged components shall be replaced immediately or the INSTRIDE PRO stepper removed |
7. | from service until repair is made. |
Only Stamina Products supplied components shall be used to maintain/repair the INSTRIDE PRO | |
| stepper. |
8.Keep your INSTRIDE
PRO stepper clean by wiping with an absorbent cloth after use.
6