JVC HX-D77 ⁄ Speakers, To connect digital audio, Press NTSC/PAL Select Ntsc or PAL, Press Enter

To select the color system	ONLY
	Remote

You can select the video output to match it to the color system of your TV.

•The color system can be changed only while DVD/CD is selected as the source and playback is stopped.

1Press NTSC/PAL.

2Select NTSC or PAL.

NTSC

PAL

NTSC: For an NTSC TV.

PAL: For a PAL TV.

•When using a multi-color system TV, either position will work.

3Press ENTER.

⁄Speakers

•When connecting the speaker cords, match their polarity with that of the speaker terminals: red/blue to (+) and black to (–).

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above instruction. If this happens, move the speakers away from the TV.

•DO NOT connect more than one speaker to each terminal.

• DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

!To connect digital audio

Protective cap

• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu correctly according to the connected digital audio equipment (see page 37). If the setting is incorrect, loud noise may be generated causing damage to the speakers.

Digital audio signals are output from this System only when DVD/CD is selected as the source.

1 Hold	2 Insert	3 Release
		Blue
From right		MAIN	From left
speaker		SPEAKER	speaker
		(6-16Ω)
Black			Black
		SUB
		WOOFER
		(3-6Ω)
		Red

DO NOT plug in any equipment until all connections are complete.

7