GETTING STARTED
Folding Handle Set-Up Instructions
To unfold the powerboard, begin by pressing down on the FOLDING HANDLE with one hand (Fig. 3), while gently pulling up on the handlebars with the other (Fig. 4). Fully extend the handlebars to their upright position until you feel the mechanism lock into place (Fig. 5).
When you first take the powerboard out of the box, the BRAKE LEVER and ACCELERATOR LEVER will be in the down position for shipping. Using the provided Allen Wrench, loosen the tension bolt, and adjust the levers to a comfortable position (Fig. 6). Then tighten the bolt. BE CAREFUL NOT TO DISCONNECT THE CABLES! You are now ready to ride your powerboard!
Fueling
IMPORTANT: This is a
PLEASE READ OPERATING PROCEDURES BEFORE FUELING!
1.Mix fuel (minimum 90 octane) and
Use Tanaka Perfect Mix or a quality 50:1
2.Make sure that the engine is off.
3.Slowly open the GAS CAP, so that possible
4.Clean the tank cap area to make sure that it is free from excess dirt and debris. NOTE: Make sure that no dirt falls into the gas tank.
5.Pour
6.After fueling, replace the GAS CAP and tighten.
Page 6