JVC LVT0900-004A, CA-UXZ7MD manual Recording Other Sources onto an MD

English

To record a single track during play or pause

On the main unit ONLY:

While playing back or pausing a track you want to record, press ONE TOUCH MD REC.

The playback of the track is stopped, and the same track starts playing from the beginning again. This time, the MD recorder starts recording the track.

•After the track is recorded, both the CD player and the MD recorder stop automatically.

To change the information shown in the main display

On the remote control ONLY:

Press DISP/CHARA.

•Each time you press the button, the recording indications, the current track numbers of both the disc and the MD, and the clock indication appear in sequence in the main display.

When recording from a CD-R/RW

You cannot make a digital recording from a digital-copied CD-R/RW on an MD. “SCMS CANNOT COPY” appears in the main display and an analog recording starts (see page 68). The recording speed is automatically set to x1 (normal speed).

Recording Other Sources onto an MD

1 Prepare the source to record.

To record FM/AM broadcasts:

Press FM/AM (or FM/AM/AUX on the remote control) to select either “FM” or “AM,” then tune in to a preset station you want.

• For more detailed operations, see pages 17 and 18.

To record a tape:

1)After putting a cassette, press TAPE 2 3, then 7 to select TAPE as the source.

2)Press REV.MODE to select the reverse mode (see page 30).

To record external equipment:

Press AUX/DVD (or FM/AM/AUX on the remote control) to select “AUX” and prepare the external equipment to play.

•Adjust the audio input level if necessary (see page 32).

•For operation of the external equipment, see the manuals supplied with it.

2 Insert a recordable MD into the MD loading slot.

•Set the MD recording length mode, “LP:”-prefix addition mode, and Group recording mode (see “Setting MD Recording Modes” on page 36).

3 Press ONE TOUCH MD REC on the main unit.

The recording starts and the MD REC indicator starts flashing on the display.

•When recording the external equipment, start playback after “AUX = MD” appears in the main display.

Ex.: When recording a tape using LP2 and Group

recording.

To put a track mark manually while recording, press SET on the remote control at the place where you want.

To stop recording, press 7.

“WRITING” flashes in the main display for a while.

When recording the external equipment

Recording starts automatically when the source sound comes into the unit, and stops automatically if no sound comes into the unit for more than 30 seconds (Sound synchronized recording).

To change the information shown in the main display

On the remote control ONLY:

Press DISP/CHARA.

•Each time you press the button, the information in the main display changes as follows:

1

2 3 4

Clock time

Ex.:When you record an FM broadcast.

1Source indication

2Remaining recording time

3 MD track No.

4 MD group No. (When Group recording is not activated, “– –” will appear.)

– 37 –