JVC LVT0900-004A, CA-UXZ7MD manual Setting the AM Tuner Interval Spacing, Tuning in to a Station

English

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change it to 9 kHz or 10 kHz spacing.

On the main unit ONLY:

To set the AM tuner to the 10 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet. While holding ¢, press . The unit turns on and tunes in to 530 kHz.

To set it back to the 9 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.

While holding 4, press . The unit turns on and tunes in to 531 kHz.

When you change the AM tuner interval spacing

The preset stations you have set (both FM and AM) will be erased. In this case, preset stations again. See “Presetting Stations” on the next page.

Tuning in to a Station

1 Press FM/AM/AUX (or FM/AM on the main unit) to select either “FM” or “AM.”

When you press the button for the first time, the unit automatically turns on with the last selected source.

On the remote control:

•Each time you press the button, the source changes as follows:

FM AM

AUX

On the main unit:

•Each time you press the button, the band alternates between FM and AM.

2 Press and hold ¢or 4(UP or DOWN on the main unit) until the station frequencies start changing continuously in the main display.

•	¢	(UP):	Increases the frequencies.
•	4	(DOWN):	Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the STEREO indicator lights up on the display.

To stop during searching, press ¢or 4(or UP or

DOWN on the main unit).

When you repeatedly press ¢or 4(or UP or

DOWN on the main unit)

The frequency changes step by step.

To change the FM reception mode

When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the reception.

On the remote control ONLY:

Press FM MODE.

•Each time you press the button, FM reception mode alternates between STEREO and MONO.

STEREO: Normally select this.

You can hear stereo sound when a program is broadcast in stereo. The STEREO indicator lights while receiving the FM stereo broadcast (only when the reception is good).

MONO: Select this when an FM stereo broadcast is noisy or hard to receive. Reception improves though stereo effect is lost. The MONO indicator lights up on the display.

To change the information shown in the main display

On the remote control ONLY:

Each time you press DISP/CHARA, the information in the main display alternates between the source indication and the clock indication.

•If an MD is inserted, the MD remaining recording time (“REC REMAIN”) is shown before the clock indication.

– 17 –