JVC LVT0900-004A, CA-UXZ7MD manual Introduction, Precautions

Page 6

English

Introduction

We would like to thank you for purchasing one of our JVC products.

Before operating this unit, read this manual carefully and thoroughly to obtain

the best possible performance from your unit, and retain this manual for

future reference.

About This Manual

This manual is organized as follows:

•This manual mainly explains playback and editing operations using the remote control, and the other operation such as recording operations using the buttons on the main unit.

You can use the buttons both on the remote control and on the main unit for the same operations if they have the same or similar names (or marks), unless mentioned otherwise.

•Basic and common information that is the same for many functions is grouped in one place, and is not repeated in each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Basic and Common Operations” on pages 10 – 15.

•The following marks are used in this manual:

Gives you warning and caution to prevent from damage or risk of fire/electric shock. Furthermore, gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Precautions

Installation

•Install in a place which is level, dry and neither too hot nor too cold—between 5˚C and 35˚C.

•Install the unit in a location with adequate ventilation to prevent internal heat buildup in the unit.

•Leave sufficient distance between the unit and the TV.

•Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

Power sources

•When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lenses inside the unit in the following cases:

•After starting heating in the room

•In a damp room

•If the unit is brought directly from a cold to a warm place Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again.

Others

•The electronic swing panel may malfunction when you use this unit under the strong light such as the sunlight.

DO NOT expose this unit to the strong light.

•Should any metallic object or liquid fall into the unit, unplug the AC power cord and consult your dealer before operating any further.

•If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Micro Component MD System UX-Z7MD-Consists of CA-UXZ7MD and SP-UXZ7MDPage English UX-Z7MD Class Laser Product Precautions IntroductionContents Location of the Buttons Main UnitMain unit Display window on the electronic swing panel Display windowRemote Control Pressing one of these buttons also turns on the unitGetting Started Connecting AntennasBefore connecting it, disconnect the supplied FM antenna UnpackingAM antenna Connecting SpeakersYou can connect the speakers using the speaker cords To connect an outdoor AM antennaTo connect external equipment Connecting External EquipmentTo remove the speaker grilles Speaker grilles are removable as illustrated belowPutting the Batteries into the Remote Control R6PSUM-3/AA15FRemote control Basic and Common OperationsTurning On the Power Setting the Auto Power OffTurning On/Off the Key-touch Tone Setting the Clock To turn off the clock indication power save modeTo check the clock time with tones To increase the volume, turn Volume + / control Clockwise If Cannot Listen appears in the main displayFor private listening Reinforcing the Bass Sound To check the sound mode currently selected, pressSound indicator goes off from the display Selecting the Sound ModesTo create your favorite colors Setting the Display IlluminationTo select the illumination color To change the display brightnessRemote control Main unit Listening to FM and AM BroadcastsTo change the FM reception mode Setting the AM Tuner Interval SpacingTuning in to a Station On the remote control only Press FM ModePress the number buttons to select a preset number Presetting StationsTuning in to a Preset Station Press SETPlaying Back CDs CD-R/CD-RW Precautions on CD Playback Playing Back the Entire CD-Normal PlayProgram Play To go to another track directly using the number buttonsBasic CD Operations To stop playback for a momentRepeating Tracks-Repeat Play To check the program contentsPlaying at Random-Random Play To modify the programPlaying Back MDs Basic MD Operations To locate a particular point in a track during playOn the remote control only Load an MD Press MD 3/8, then About MD indicatorWhile playing or pausing To change the information shown in the main displayTracks are played at random To erase the entire program, press MD 0 to eject the MDTracks of the loaded MD will play at random To skip the playing track, press ¢To go to another track in the same group, press ¢ or Playing Tracks in a Group-Group PlayPress Group Skip or Group Skip to select a group To go to another group, press Group SkipSearching for Tracks to Play MD Title Search Playing Back Tapes Push Push Open To play both sides-Reverse modePlaying Back a Tape Put a cassette in with the exposed part of the tape downListening to External Equipment Adjusting the Audio Input Level For how to apply sound effects, seeListening to External Equipment Recording To avoid erasing important recordings Before You Start Recording on an MDAbout the track marks To put a track mark manually while recording anAbout High-Speed Recording Precautions for performing long-hour stereo recordingStereo Long-Hour Recording Mdlp To check the remaining recording timeTo set LP-prefix addition mode Setting MD Recording ModesTo set the recording length mode To set Group recording modeRecording Other Sources onto an MD To record a single track during play or pauseTo protect your recordings To clean the heads, capstans, and pinch rollersBefore You Start Recording on a Tape To keep the best recording and playback sound qualityPrepare the source to record To record a disc Recording onto a TapeTo record a single track of a CD/MD during play To record an MDFor the tape Press REV.MODE to select the reverse modeWhen recording on an MD and a tape at the same time Press MD&TAPE RECEditing MDs Guidance-MD Group Functions Using MD Group functionsHow to make up Groups Classifying the tracks on an MDIntroducing Group Editing Functions Press ¢or 4to select the first track of a new group Forming a Group-FORM GRPress SET During playback Press ¢or 4to select the last track of the new groupPress ¢or 4to select the track When Cannot ENTRY! appears in stepAdding a Track to a Group-ENTRY GR Or Group SkipDividing a Group-DIVIDE GR To join the divided groups again, see the Join GRFunction on When Cannot Join appears in step Joining Two Groups-JOIN GRTo divide the group again, see the Divide GR function Moving a Group-MOVE GR To cancel the setting, press Cancel Ungrouping Tracks-UNGROUPDissolving All Groups-UNGR ALL Erasing Tracks in a Group-ERASE GR Introducing Track Editing Functions Press ¢or 4to select the track you want to divide Press or to precisely adjust the dividing pointDividing a Track-DIVIDE To join the divided tracks again, see the Join functionTo divide the joined tracks, see the Divide function on When the track belongs to a groupJoining Two Tracks-JOIN If Cannot Join appears in stepMoving a Track-MOVE Press ¢or 4to select the track you want to moveErasing Tracks-ERASE Erasing All Tracks-ALL ErasePress SET Press ¢or 4to select the track you want to erase For the group title Press or to change the title entry modeAssigning Titles to an MD For the disc and track titlePress Enter to finish the current title entry Press Cancel to exit from the title entry modeRepeat steps 5 1 and 5 2 to enter other characters For the disc titleChanging the Title You can make a correction or change the titleMake sure that the character you want to change is flashing Using the Timers Using Recording Timer How Recording Timer actually worksTo turn off the Recording Timer after its setting is done Using Daily TimerHow Daily Timer actually works To turn on the Recording Timer againVolume setting appears in the main display To turn off the Daily Timer after its setting is doneTo turn on the Daily Timer again If the unit is kept turned on when the timer-on time comesUsing Sleep Timer Timer PriorityHow Sleep Timer actually works Maintenance MD Disc Types Utoc User Table Of ContentsAdditional Information Atrac Adaptive TRansform Acoustic Coding/ATRAC3Hcms High-speed Copy Management System Symptoms CauseScms Serial Copy Management System MD limitationsCD/MD Messages Cannot REC x1 or x2 onlyEnglish Troubleshooting SymptomSpecifications AUX/DVDEN, CS 0602MWMMDWJEM

CA-UXZ7MD, LVT0900-004A specifications

The JVC LVT0900-004A, CA-UXZ7MD is a sophisticated compact audio system designed for music enthusiasts who appreciate both sound quality and versatility. This system reflects JVC's commitment to delivering exceptional audio experiences with advanced technologies and features that cater to various listening preferences.

One of the standout features of the CA-UXZ7MD is its powerful audio output, which is achieved through a dynamic speaker system. This allows users to enjoy rich, room-filling sound whether they're listening to music, watching movies, or even gaming. The system is equipped with a built-in amplifier that enhances the overall audio performance, ensuring clear highs, balanced mids, and deep, resonant bass.

In terms of connectivity, the CA-UXZ7MD is designed to accommodate modern streaming habits. It offers Bluetooth functionality, allowing users to wirelessly connect their smartphones, tablets, or laptops. This feature is complemented by a USB port that enables playback from USB drives and devices, providing further flexibility in how users access their music libraries. Additionally, the system supports various audio formats, ensuring compatibility with different file types for seamless playback.

The user-friendly interface of the CA-UXZ7MD makes it easy to navigate through different audio sources and settings. The clearly labeled control buttons and intuitive layout enhance the overall user experience, making it accessible for individuals of all ages. The built-in FM tuner also adds another dimension to its functionality, allowing users to enjoy their favorite radio stations with ease.

JVC has incorporated advanced sound processing technologies into the CA-UXZ7MD to further elevate audio quality. Features such as equalizer presets enable users to tailor the sound profile to match their preferences or the music genre being played. This level of customization enhances the listening experience, making it more enjoyable and immersive.

The compact design of the CA-UXZ7MD makes it an ideal choice for various settings, whether it's a small apartment, a home office, or even a bedroom. Its sleek aesthetics ensure that it fits seamlessly with any decor while providing powerful audio performance.

In summary, the JVC LVT0900-004A, CA-UXZ7MD stands out as a versatile and high-quality compact audio system. With its robust sound output, extensive connectivity options, user-friendly interface, and advanced sound processing features, it caters to the diverse needs of modern audio consumers. This system is not just about playing music; it’s about creating a memorable auditory experience that can be enjoyed anytime, anywhere.
Top Page Image Contents