Omron BF510 instruction manual Error Displays, Troubleshooting

6. Error Displays

Error Display	Cause	Correction
	Your palms or soles are not in firm contact	Press your palms or soles firmly to the
		electrodes, then measure. (Refer to Section
	with the electrodes.
		4.)
	The posture for measurement is wrong or	Measure without moving the hands or soles.
	the palms or soles are not in firm contact
		(Refer to Section 4.)
	with the electrodes.
	The palms or soles are too dry.	Moisten the palms or soles with a wet towel,
		then repeat measurement.
		• Please ensure that age, gender and height
		settings stored as personal data are
	Values of body composition are out of	correct (see Setting Items in Section 9).
		• The main unit cannot measure body
	measurable range.
		composition outside its measurement
		range, even if the Age, Gender and Height
		settings are correct.
		Insert the batteries again and repeat
	Abnormal operation.	measurement.
		If this error still occurs, consult your
		OMRON service representative.
	You stepped on the unit before the display	Step on the main unit after the display
	indicated “0.0 kg”.	indicates “0.0 kg”.
	You moved the main unit before the display	Do not move the main unit until the display
	indicated “0.0 kg”.	indicates “0.0 kg”.
	You moved your body while measuring body	Do not move while measuring body weight.
	weight.
		Body weight of 150 kg (330.0 lb) or over is
	Your weight is 150 kg (330.0 lb) or over.	out of the measuring range of this unit. You
		cannot use this unit.

7. Troubleshooting

Problem	Cause	Correction
The displayed value of body
composition is abnormally high or	Refer to “Useful Information”.
low.
The power turns off approximately 5	You did not select the correct
minutes after the body weight is	personal profile number or the	Select the correct personal profile
confirmed and before your body fat
	GUEST mode. (The personal profile	number or the GUEST mode. (Refer
percentage, visceral fat level and
	number or “G” is not displayed on	to Section 4.)
skeletal muscle percentage is
	the display unit.)
measured.
	Batteries are not inserted.	Insert the batteries.
	The polarities of batteries are not	Insert the batteries in correct
	aligned correctly.	alignment.
Nothing is displayed when the
	The batteries are worn out.	Replace all four batteries with new
power is turned on.		ones. (Refer to Section 2.)
	The cord connecting the main unit	Contact the nearest OMRON
	and the display unit is damaged or
		service representative.
	worn.

EN

11