SET UP Instructions, Function Inspection

SET UP INSTRUCTIONS

Place the Avari GX8 in the area where it will be used. It is recommended that the Avari GX8 be placed on an equipment mat. The maximum usage dimensions of Avari GX8 are approximately 99 1/4" long x 25 5/8" wide x 64 7/8" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 9 feet long is required for safe operation of the AvariGX8. Make sure that adequate space is available for access to and passage around the AvariGX8.

LEVELING: Adjust the STANDS(59) under the MAIN FRAME(1) so that the AvariGX8 sits on the floor without rocking. Refer to the instructions below the illustration.

MOVING: Move the Avari GX8 with the moving wheels on the REAR STABILIZER(2). Lift from the Front Stabilizer of the MAIN FRAME(1). Two people are required to move the Avari GX8.

To level the Avari GX8, first screw the STAND(59) located in the middle of the MAIN FRAME(1) all the way up into the MAIN FRAME(1) so that it is not touching the floor.

Adjust the four STANDS(59) on each of the four

corners, two under REAR STABILIZER(2) and

two under the front of the MAIN FRAME(1). When all four are adjusted and the AvariGX8 is stable, tighten the NUTS(3/8"-16)(79)against the MAIN FRAME(1) and REAR STABILIZER(2) to lock the STANDS(59) into position. While you are adjusting these four STANDS(59), the one STAND(59) located in the middle of the MAIN FRAME(1) must not be in contact with the floor. Only after the AvariGX8 has been stabilized with

the four STANDS(59) on the corners will you position the middle STAND(59) so it is in contact with the floor to provide extra stability for the MAIN FRAME(1).

Equipment Mat

Lift up from the Front Stabilizer for moving.

FUNCTION INSPECTION:

Visually inspect the Avari GX8 to verify that assembly is as shown in the above illustration. Check the function of the Avari GX8. Stand on the foot pedals and place your hands at a comfortable position on the handlebars. Slowly move your highest foot forward and follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify that the drive train functions properly. Use the "Quick Start" and "+/-"buttons on the COMPUTER(20) to select a program and verify that the Generator System provides different tensions. Refer to the COMPUTER INSTRUCTIONS on pages 17 to 22.

CAUTION: Locate and read the WARNING LABEL(95) on the AvariGX8. Make sure that all users read the WARNING LABEL(95).