Horizon Fitness SXE 7.7 manual S E M B LY Step

INTRODUCTION

A S S E M B LY STEP 2

A S S E M B LY STEP 3

INTRODUCTION

IMPORTANT

PRECAUTIONS

ASSEMBLY

YOU

BEFORE

BEGIN

FLAT WASHER (D)

SPRING WASHER (C)

BOLT (B)

MAIN FRAME

CONSOLE MAST

PRE-ATTACHED

SCREWS

WATER BOTTLE HOLDER

TOP COVER

CONSOLE MAST

LOWER HANDLEBAR

PRE-ATTACHED

BOLT & WASHER

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION
GUIDELINES
CONDITIONING
&MAINTENANCE
TROUBLESHOOTING
LIMITED
WARRANTY
	

A) Open HARDWARE BAG FOR STEP 2.

B)Carefully slide the TOP COVER up over the CONSOLE MAST.

C)Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the

CONSOLE MAST.

D)Attach the CONSOLE MAST to the MAIN FRAME using 7 BOLTS (B), 7 SPRING WASHERS (C) and

7 FLAT WASHERS (D).

E)Slide the TOP COVER down onto the MAIN FRAME.

F)Attach the WATER BOTTLE HOLDER to the CONSOLE MAST using 2 PRE-ATTACHED SCREWS.

HARDWARE BAG FOR STEP 2 CONTENTS :
	BOLT (B)	SPRING WASHER (C)	FLAT WASHER (D)
	15 mm	15.4 mm	20 mm
	Qty: 7	Qty: 7	Qty: 7

A)There is no hardware bag for this step.

B)Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MASTS.

C)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by using PRE-ATTACHED BOLTS & WASHERS.

Reminder: The upper and lower handlebars are marked with an L if they are to be used on the left-hand side of the elliptical or an R if they are to be used on the right-hand side of the elliptical. If the handlebars are assembled on the incorrect side of the elliptical, the unit will not function correctly.

	After handlebars are assembled they will rotate freely – be cautious. Until the
WARNING
	machine is fully assembled, do not grab the handlebars for support.



ELLIPTICAL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

SXE7.7_Rev.1.6.indd 8-9 8/16/07 11:01:12 AM