JVC CA-UXB70 Listening to FM and AM MW Broadcasts, Tuning in to a Station, Presetting Stations

Page 16

Listening to FM and AM (MW) Broadcasts

Tuning in to a Station

1 Press FM/AM to select either “FM” FM/AM or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM (MW).

•Each time you press the button, the band alternates between FM and AM (MW).

Presetting Stations

You can preset 30 FM and 15 AM (MW) stations manually.

In some cases, test frequencies have been already stored for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 2.

2 Press and hold ¢or 4 (or ¢UP or 4DOWN on the unit) for more than 1 second.

•¢(¢UP): Increases the frequencies.

•4(4DOWN): Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the STEREO indicator lights up on the display (only when the reception is good).

To stop during searching, press ¢or 4(or ¢UP or

4DOWN on the unit).

On the remote control ONLY:

1 Tune in to the station you want to preset.

• See “Tuning in to a Station.”

2 Press SET.

SET

 

“SET” starts flashing on the display.

3 Press DISC UP or DISC

DISC UP

 

DOWN to select a preset number.

 

 

DISC DOWN

When you repeatedly press ¢or 4(or ¢UP or 4DOWN on the unit)

The frequency changes step by step.

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive

FM

or noisy, press FM MODE so that the MONO

MODE

 

indicator lights up on the display. Reception will

 

improve.

 

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.

You can also select the preset number by the number buttons.

Ex.: For preset number 5, press 5. For preset number 15, press +10,

then 5.

For preset number 20, press +10, then 10.

For preset number 30, press +10, +10, then 10.

1 2 3

4 5 6

7 8 9

10+10

13

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Instructions Important for Laser Products Above ALL Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront panel Display window on the front panel Display windowRemote Control See pages in parentheses for detailsConnecting Antennas Getting StartedUnpacking FM antenna To connect an outdoor FM antennaConnecting Speakers Release your finger from the clampAM MW antenna To connect an outdoor AM MW antennaConnecting Other Equipment Putting the Batteries into the Remote ControlTo remove the speaker grilles To connect audio equipmentSetting the Clock On the remote control only Press CLOCK/TIMEROn the remote control only Press Disc UP or Disc Down to adjust the minute, then pressTurning On the Power To turn off the unit automatically Auto StandbyAdjusting the Volume On the remote controlReinforcing the Bass Sound On the unitAdjusting the Tone Changing the Display BrightnessPresetting Stations Tuning in to a StationListening to FM and AM MW Broadcasts Tuning in to a Preset Station Press SET againOn the remote control only Press PTY Search Receiving FM Stations with RDSChanging the RDS Information Searching for Programs by PTY Codes PTY SearchSwitching Temporarily to a Program Type of Your Choice Type you want flashes on the displayWait for about 3 seconds after specifying the data type To activate the Enhanced Other Networks functionWhen playing a CD-R or CD-RW About the disc indicatorsPlaying Back Discs on the 5-CD Changer Loading DiscsPlaying Back All the Entire Discs -Continuous Play Basic Disc OperationsOn the remote control On the remote control only On the remote control only Load discs into the 5-CD ChangerPress Play Mode repeatedly until Programing the Track Playing Order -Program PlayTo check the program contents Playing at Random-Random PlayProgram other tracks you want CD Random appears on DisplayRepeating Tracks or Discs-Repeat Play Prohibiting Disc EjectionPress REV.MODE reverse mode Playing Back TapesPlaying Back a Tape Prohibiting Cassette EjectionRecording Recording on a TapeCheck the recording direction for the tape Press REC recordingRecording Discs Disc Synchronized Recording Press CD REC Mode on the remote When recording discsControl to select ALL CD Press RECControl to select 1ST Track Press REC while 1ST Track stillYou want to record First Track RecordingUsing the Timers Using the Daily Timer and the Recording TimerSet the on-time you want the unit To turn onAdjust the clock if needed To deactivate the timer temporarily, pressWhen you have selected CD Program in step Press STANDBY/ON to turn off the unit if the unit is onOn the remote control only Press Sleep Using the Sleep TimerHow the Sleep Timer actually works Maintenance Cleaning the unitHandling discs To keep the best recording and playback sound qualitySymptom TroubleshootingPossible Cause Action Specifications Additional InformationUX-B70 Micro Component System

SP-UXB70, CA-UXB70 specifications

The JVC SP-UXB70 and CA-UXB70 are compact audio systems designed to deliver high-quality sound and versatile playback options. With their modern design and robust features, these systems cater to both casual listeners and audio enthusiasts.

One of the standout features of the JVC SP-UXB70 is its powerful audio output. The system boasts a peak power of 240 Watts, ensuring that it can fill any room with rich sound. The inclusion of a high-performance woofer enhances bass response, providing an immersive listening experience for music, movies, and more.

The CA-UXB70 component serves as the central hub of the audio system. It comes equipped with a built-in CD player, allowing users to enjoy their favorite CDs with ease. Additionally, the system supports various playback formats, including MP3 and WMA, which are ideal for digital music collections. For users who prefer wireless connectivity, Bluetooth compatibility is a significant advantage, enabling seamless streaming from smartphones and tablets without the need for cables.

Another impressive feature of the JVC SP-UXB70 is its FM/AM tuner, offering access to a wide range of radio stations. Users can easily program their favorite stations, making it convenient to enjoy live broadcasts. The system also includes a USB port, allowing for direct playback from USB drives, further enhancing its versatility.

The design of the JVC SP-UXB70 is both stylish and functional. Its compact size allows it to fit into various spaces without sacrificing sound quality. The user-friendly interface makes it easy to navigate through different functions and settings. The inclusion of a remote control adds convenience, allowing users to adjust settings from a distance.

Moreover, the system features a range of sound enhancement technologies, including a built-in equalizer. This allows users to tailor the sound experience to their preferences, whether they enjoy bass-heavy tracks or crystal-clear vocals. The JVC SP-UXB70 and CA-UXB70 are equipped to meet diverse listening needs, providing an audio solution that is adaptable and high-performance.

In summary, the JVC SP-UXB70 and CA-UXB70 stand out as excellent choices for anyone in search of a compact, feature-rich audio system. With their powerful sound output, versatile playback options, and modern design, these systems are perfect for enhancing any audio experience, be it at home or on the go.
Top Page Image Contents