Horizon Fitness E901 manual S E M B LY Step, Remove PRE-ATTACHED Bolt & Washer from Console Mast

RIONINT
ODUCT
R
IREP
PO
ONS
IM
CAUT
TANT
BLYEM
ASS
E
RE EFO
YOUBING
B
ICAL
IPT
ER
LLE
OPION
AT
ING
I E
ONTI
IN
LE
ID
COND
GU
E S
I NANCNT&A
E E
R
T I
NG
OUBL
M
SHOOT
DET
RR
WA
IMI
L
ANTY
	10

A S S E M B LY STEP 4
CONSOLE MAST	PRE-ATTACHED WASHERS
	LOWER HANDLEBAR
	UPPER	PRE-ATTACHED
	HANDLEBAR	SCREWS
	PRE-ATTACHED
	WASHER & BOLT
		HANDLEBAR COVERS

NOTE: There is NO hardware bag for this step. All hardware is pre-installed.

ARemove PRE-ATTACHED BOLT & WASHER from CONSOLE MAST.

BSlide lower HANDLEBAR onto CONSOLE MAST and attach by re-insertingPRE-ATTACHED WASHER & BOLT.

CRemove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR.

DSlide UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED SET SCREWS.

	After handlebars are assembled they will rotate freely – be cautious. Until
WARNING
	the machine is fully assembled, do not grab the handlebars for support.

eRemove PRE-ATTACHED SCREWS located on the front and back of the HANDLEBARS. F Attach HANDLEBAR COVERS with PRE-ATTACHED SCREWS.

G Repeat on other side.

A S S E M B LY STEP 5

FOOTPAD

LINK ARM

WASHERS (G)

SCREWS (F)

AOpen HARDWARE BAG FOR STEP 5.

BAttach FOOTPAD to LINK ARM using 4 SCREWS (F) and 4 WASHERS (G).

CRepeat on other side.

HARDWARE BAG FOR STEP 5 CONTENTS :

SCREW (F)	WASHER (G)
16 mm	18 mm
Qty: 8	Qty: 8

11

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

LIMITED TROUBLESHOOTING CONDITIONING ELLIPTICAL WARRANTY & MAINTENANCE GUIDELINES OPERATION

E901_Rev.1.7.indd 10-11 9/10/08 11:06:57 AM