Horizon Fitness E901 manual Open Hardware BAG for Step, Console Mast, Do not Pinch Wires

RIONINT
ODUCT
R
IREP
PO
ONS
IM
CAUT
TANT
BLYEM
ASS
E
RE EFO
YOUBING
B
ICAL
IPT
ER
LLE
OPION
AT
ING
I E
ONTI
IN
LE
ID
COND
GU
E S
I NANCNT&A
E E
R
T I
NG
OUBL
M
SHOOT
DET
RR
WA
IMI
L
ANTY
	

	A S S E M B LY STEP 2
				CONSOLE
	SPRING WASHERS (C)	CONSOLE MAST		MAST
				WATER
	BOLTS (B)	ARC WASHERS (E)	BOLTS (B)	BOTTLE
				HOLDER
				PRE-ATTACHED
				SCREW
	FLAT WASHERS (D)
	CONSOLE MAST BOOT
	CONSOLE CABLE		MAIN FRAME
A	Open HARDWARE BAG FOR STEP 2.

BSlide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST above bolt holes as shown above.

CCarefully pull the CONSOLE CABLE through the CONSOLE MAST using the twist tie located inside the

CONSOLE MAST.

DAttach the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (B), 2 SPRING WASHERS (C) and 2 FLAT WASHERS (D) in each side and 2 BOLTS (B), 2 SPRING WASHERS (C) and 2 ARC WASHERS (E) in the front of the console mast. Slide CONSOLE MAST BOOT down to cover main frame.

DO NOT PINCH WIRES!

e Attach the WATER BOTTLE HOLDER to the mast using 2 PRE-ATTACHED SCREWS.

HARDWARE BAG FOR STEP 2 CONTENTS : ARC

BOLT (B)	SPRING WASHER (C)	FLAT WASHER (D)	WASHER (E)
			17 mm
20 mm	15 mm	20 mm
			Qty: 2
Qty: 6	Qty: 6	Qty: 4
			angle view

A S S E M B LY STEP 3

PEDAL ARM COVER

PRE-ATTACHED SCREW

PRE-ATTACHED SCREW

PEDAL ARM

ROLLER WHEEL COVER

NOTE: There is NO hardware bag for this step. All hardware is pre-installed.

AAttach the PEDAL ARM COVER to the right PEDAL ARM using PRE-ATTACHED SCREW.

BAttach the ROLLER WHEEL COVER to the right PEDAL ARM using PRE-ATTACHED SCREW.

CRepeat on the other side.

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

LIMITED TROUBLESHOOTING CONDITIONING ELLIPTICAL WARRANTY & MAINTENANCE GUIDELINES OPERATION

E901_Rev.1.7.indd 8-9 9/10/08 11:06:50 AM