Maytag 2006 owner manual Electrical SYSTEM, Satellite Antenna Wiring

Electrical SYSTEM

SATELLITE ANTENNA WIRING

If you compare the two previous drawings you’ll see wiring for a satellite dish antenna is relatively simple.

Units have a faceplate with two coax cable hook-ups. It is located in the TV credenza on all models except the slide-out model with the overhead TV, which is located in the cabinet to the roadside of the TV. The faceplate has a small coax cable jumper running between the hook-ups to complete the cable TV circuit when in use. To install a satellite system use the following procedure:

1.	Remove the jumper wire from the coax faceplate.
2.	Hook a portable dish into the Cable TV receptacle in
	the roadside rear underbelly compartment. This feeds	G
	the dish signal to the input side of the faceplate.
3.	Install the satellite receiver input and output into the
	dual coax faceplate.

To return to a cable TV system, remove the satellite receiver from the faceplate and reinstall the

jumper cable.

G - 9