TV ANTENNA
Manufacturer:
Winegard Company
3000 Kirkwood Street
Burlington, Iowa 52601
Phone:
Raising Antenna to Operating Position
Turn elevating crank in “UP” direction until some resis- tance to turning is noted. Antenna is now in operating position. Check to make sure switch on front TV jack is on.
Rotating Antenna
Make sure antenna is in “UP” position. Pull down on directional handle with both hands until it disengages ceiling plate and rotate for best picture and sound on television set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional handle aligns with pointer on ceiling plate.
Warning: Antenna must be in “down” position while traveling to prevent damage.
Turn elevating crank in the “Down” direction until resis- tance is noted. Antenna is now locked in
travel position.
Checking Operation
1.Tune TV receiver to nearest station and rotate an- tenna for best picture and sound.
2.Turn off switch on power supply. Picture on TV receiver should be considerably degraded with the power off.
DO’S
1.Do check parking location for obstructions before raising antenna.
2.Do carefully raise, lower and rotate - if difficult, check for cause.
3.Do rotate slowly when selecting station and check
4.Do lower antenna before moving vehicle.
DON’TS
1.Don’t force elevating crank up or down. Check for cause of trouble.
2.Don’t rotate directional handle hard against stops.
3.Don’t travel with lift in up position.
4.Don’t leave lift part way up or down.
5.Don’t apply sealing compound or paint over top of base plate or anywhere on lift.
Electrical SYSTEM
G
G - 7
