Maytag 2006 owner manual Plumbing, Microtech Filter Installation/Replacement

Plumbing

MICROTECH™ FILTER

INSTALLATION/REPLACEMENT

1. Install a new filter by wetting the outlet ports with water and then inserting into the round filter ports on the faucet head and pushing the filter and head together. Both outlet ports must be fully inserted into the filter ports.

	2. Install the filter and faucet head assembly on to the
	spout by wetting the faucet head o-ring seal and
	then carefully sliding the free end of the filter into
	the spout. The head will need to be initially turned
F	approximately 1/2 turn counter clockwise from its
	normal position to slip past the safety catch. Lock
	the head into place by simultaneously pushing and
	twisting the head clockwise. When properly installed
	the head will feel secure, and will be correctly ori-
	ented on the spout.
	3. Reset the filter life indicator by pushing the filter
	button 3 times. Wait 10 seconds. You should not be
	running water while resetting the filter life indicator
	because the filter button will remain depressed, with
	the first push as it switches to filter mode. The filter
	life indicator has been correctly reset if a short series
	of rapidly flashing green light occurs, indicating that
	the new filter-flushing period has begun.
	4. Flush the filter for 5 minutes before initial use.
	Your new Moen faucet is now ready for normal use.

To replace filter:

1.Turn off the faucet. Remove the faucet head by twisting it approximately 1/4 turn counter clockwise to unlock it. Gently pull the faucet head away from the spout and twist it approximately another 1/4 turn to get the faucet head past the safety catch. The faucet head and depleted filter (if one is installed) can now be pulled completely out of the spout.

2.The filter is held to the faucet head by two outlet ports, which connect into the head. Remove the old filter by simply pulling it straight off. Discard the old filter and install a new MicroTech 400 or 600 filter.

Note: The faucet will function correctly in unfiltered stream mode with or without a filter installed. The faucet will not function correctly in filter mode without a filter. If a filter is not installed and the filter button in depressed, unfiltered water will flow from both the filtered water outlet and the stream outlet aerator, and the filter button will not automatically stay depressed.

Use only Microtech 400 or 600 filter cartridges with the PureTouch Classic Filtering Faucet system. The Microtech filters are high performance carbon block fil- ters developed specifically for the PureTouch system.

F - 15