Maytag 2006 owner manual Electrical SYSTEM, Back Up Camera Pre-Wire, INVERTOR option

C. Using a voltmeter check voltage output between heavy positive and negative wires coming out of converter.

D. The voltage must be within 13.8 and 14.0 volts. (The meter of the tester should be calibrated periodically.)

E. If converter is not within these voltages, have it serviced by a qualified techni- cian or replace it.

Note: The 7 way wire is spliced to the main harness in the area of the 12-volt distribu- tion panel in front of the trailer.

One of these wires is not spliced onto a wire of the same color. It is the back up wire that is yellow in the cable and black in the harness.

BACK UP CAMERA PRE-WIRE

Your trailer has a 2-pin power connector pre-wired into the running light 12-volt system for the installation of a Power Line Vision System made by Power Linx. For more infor- mation on this system contact PowerLinx at their website or call http://rvenjoyment. com/rearview.htm.

INVERTOR (option)

The Inverter powers the TV and one additional labeled 110 volt receptacle. The inverter converts 12 volt electricity from your batteries into 110 volt power. The switch for the inverter is locatedunder the monitor panel. Overloading the inverter will cause a automatic shut off to activate. Removing the load will allow the inverter to reset.

Electrical SYSTEM

G

G - 5