Appliances
MICROPULSE SYSTEMS MONITOR OPERATION INSTRUCTIONS | NORMAL OPERATION |
This example shows the monitor reporting the following:
Fresh Water = 7/8 to Full
Gray Water 1 = Empty to 5/8
Gray Water 2 = 3/4
Black Water = Empty to 5/8
LP Gas = 1/4
Battery = Empty to 5/8
On all diagrams the Letters R=Red, Y=Yellow, G=Green, Blank=no LED lit.
The MicroPulse Monitor will display the condition of each system at all times. The
Fresh Water, LP Gas, Battery are as follows:
Green LED = 3/8 to Full
Yellow LED = 1/4
Red LED = 1/8 to Empty
Gray Water, Black Water are as follows:
Green LED = Empty to 5/8
Yellow LED = 3/4
Red LED = 7/8 to Full
TO OBTAIN EXACT READING
To obtain an exact reading of all systems press and release the status button one
time. The monitor will flash the LED beside the system it is about to report. It will than H display the exact condition of that system by lighting the bar graph from Empty to Full.
The monitor will display the exact condition of each system and then return to normal operation mode.
To obtain an exact reading of an individual system press and release the status button until the LED beside the system that you want the condition of is lit. Release the status button and the monitor will display the exact condition of that system by lighting the bar graph from Empty.
NOTE: The steel LP tanks on the Safari Models do have a level sensor. The monitor system does not read LP Gas levels.
H - 7
