Maytag 2006 owner manual Monitor Panel, Monitor Wire Connections

Appliances

MONITOR PANEL

Micropulse Systems Monitor

CATCON PRODUCTS INC.

817-921-2188 sales@catconproducts.com techsupport@catconproducts.com

H	The MicroPulse System makes use of a single solid-state sensor per tank. The
	MicroPulse sensor measures the static (head) pressure at the bottom of the tank and
	transmits this information to the MicroPulse System Monitor.  Knowing this pressure
	value, after a one-time calibration has been performed, the MicroPulse System will
	calculate and accurately display the tank level in 1/8 increment.
	A single sensor is installed on the sidewall of each tank, near the bottom, via a 3/4”
	female NPT spin-in thread. The sensor is solid state, there are no moving parts to wear
	or maintain.  Because the principle of operation does not involve any electrical current
	flow through the tanks contents (conducted or induced), the nature of the fluid in the
	tank is unimportant.

The monitor system has been calibrated at the factory and should never need another calibration. If you feel the system is not operating correctly, please contact CATCON Products or a local Airstream dealer. The following instructions are provided for quali- fied service technicians.

MONITOR WIRE CONNECTIONS
Red	12VDC, Battery Only
Black	Ground, Battery Only
Purple	Water Pump, 15A, 12VDC
White	LPG Sensor, 90 ohm
Fresh	Fresh Tank Sensor
Gray 1	Gray 1 Sensor
Gray 2	Gray 2 Sensor
Black	Black Sensor

H - 6