Precor UBK 800-SERIES warranty Installing the Upright Support and Cables, Is properly installed

16 Assembling and Maintaining UBK 800-Series Upright Exercise Bikes

Installing the Upright Support and Cables

DANGER Do not attempt to connect electrical power until all assembly procedures are complete and the console

is properly installed.

Before you begin this procedure, retrieve the cables for the console that you plan to install on this exercise bike. The cables are packed with the console.

Note: You will need the help of another person while performing the procedure.

To prepare the bike for installation of the upright support:

1.Retrieve the cables from the box in which the console was shipped.

2.Using a #2 Phillips screwdriver, remove the two #10 x

1-inch self-tapping screws holding the rear cover in place. Pull the upright rear cover back to remove it, then set it aside.

Figure 2: Rear cover removal

3.Remove the two #10 x 1-inch self-tapping screws holding the top cover in place, then lift it off.

Figure 3: Top cover removal