Precor UBK 800-SERIES warranty Connecting the Television Cable, To connect the television cable

Page 28

26	Assembling and Maintaining UBK 800-Series Upright Exercise Bikes
	Cable	Connector Type	Circuit
			Connector
			Location
	Heart rate sensors	Four-contact strip, keyed
	Safety key	Six-contact strip, keyed
	(treadmills only)
	CSAFE	Eight-contact modular, on
		flat gray cable
	Auto Stop sensor	Four-contact strip, keyed
	(treadmills only)

To simplify installation and maintenance, route and connect cables 1 through 5 according to the following instructions.

Note: In the illustrations in this section, some cables are omitted for the sake of clarity.

Connecting the Television Cable

The console’s television tuner is mounted inside the console’s back plate. The tuner includes a short cable adapter that allows the television cable to be connected outside the back plate.

To connect the television cable:

1.Pull the cable out through the lower right corner of the back plate.

2.Route the cable counterclockwise around the outside of the back plate.

3.Attach the connector on the cable to the connector on the tuner cable and tighten the two connectors securely using two ⁷₁₆-inch open-end wrenches. Position both connectors above the upper right corner of the back plate.

4.Use a plastic tie to secure the connectors to the top of the back plate. Pass the tie through the two small holes near the upper right corner of the back plate, then wrap it around the connectors and tighten it securely. Cut off and remove the protruding end of the tie.

Image 28

Contents

Page Page Page Trademark Note Edition InformationIntellectual Property Notice Important Safety Instructions Safety PrecautionsPage Educating Users Product Recycling and Disposal Hazardous Materials and Proper DisposalRegulatory Notices for the Rfid Module Radio Frequency Interference RFI Federal Communications Commission, PartIndustry Canada Void the user’s authority to operate the equipmentSafety Approvals for Cardiovascular Equipment Regulatory Notices for Cardiovascular Exercise EquipmentEuropean Applications Cardiovascular Type EquipmentUser’s authority to operate the equipment Obtaining Service Obtaining Updated Documentation IEC-320 C13 and C14 plugsTable of Contents Commercial Cardiovascular Equipment Limited Warranty To prepare the exercise bike for assembly Assembling the Exercise BikeUnpacking the Equipment To unpack the bikeRequired Tools Hardware Kit not to scaleFasteners To prepare the bike for installation of the upright support Installing the Upright Support and CablesIs properly installed Side cover removal Upright support insertion Installing the Bottle Holder To install the bottle holderInstalling the Handlebars To install the handlebarsBreaking in the Equipment Making Sure the Unit Is StableTo level the unit Page Installing the Console Threading the Cable Assembly P80To thread the cable assembly Removing the access cover from the P80 consoleConnecting Cables P80 LocationCable Connector Type Circuit Location Connecting the Television CableTo connect the television cable Connecting the Ethernet and Base Unit Data Cables Connecting the television cableConnecting the Heart Rate Sensor Cable Connecting the Power CableThreading the Cable Assembly P30 and P20 Completing the Console Installation P80To complete the installation To thread the cable assembly Connecting Cables P30 Connecting Cables P20 Completing the Console Installation P30 and P20 Verifying That the Heart Rate Display Is Operational To verify that the heart rate display is operationalMaintenance Daily CleaningDaily Inspection To perform quarterly maintenance Quarterly MaintenanceStoring the Chest Strap Long-Term Storage Moving the EquipmentTo move the exercise bike Minimum requirements for operation Self-Powered FeaturesRate of Motion Symptoms of a Low Battery Informational Displays Prior to ShutdownUsing the Optional Power Adapter Optional Power Adapter KitReplacing the Battery Limited Warranty Commercial Cardiovascular Equipment Limited WarrantyWarranty Periods and Coverage Conditions and Restrictions Exclusive Remedies Exclusion of Consequential and Incidental Damages Complete this portion and keep for your recordsCommercial Cardiovascular Equipment Limited Warranty Page Page Precor Incorporated Operating and Maintaining the P30 Console Page Page Edition Information Important Safety Instructions Operating and Maintaining the P30 Console  Do not lean on or pull on the console at any time Hazardous Materials and Proper Disposal Regulatory Notices for Cardiovascular Exercise Equipment 240 V Equipment Designated for U.S. Markets 120-volt, 20-amp power plug 240-volt, 20-amp power plugOperating and Maintaining the P30 Console 240 V Equipment Designated Operating and Maintaining the P30 Console Activating the Console for Self-Powered Equipment Activating the Console for Self-Powered EquipmentGetting Started Optional Use of the Power Adapter Identifying Parts of the Console Number Part Name Details Watts Number Part Name Details Setting Up the Console System SettingsNavigational keys for the system setting modes Key To view the Club Parameters settings5 1 5 6 Setting Club Parameter Values Safety Code Treadmill onlySelect Language All Equipment Set Units All EquipmentSet Max Pause Time All Equipment Set Max Workout Time All EquipmentSet Cool Down Time All Equipment Creating a Custom Workout Value Range on or OFFTo create a custom program Custom Program keys Equipment Key Name DescriptionSet Incline Limit Treadmill only Set Speed Limit Treadmill onlyHidden Programs Treadmill only Set Crossramp Auto Level EFX Dual only Set Resistance Range Bike onlyValue Range 0 to To view the System settings Viewing the Informational DisplaysInformational Displays values Value Information providedEvent Log Product Value Information providedEvent Description of Event Number Csafe access keys Keys Function User ID Entry with Csafe EquipmentOperating and Maintaining the P30 Console Using the Touch Heart Rate Feature Introducing Users to the P30 ConsoleHeart rate target zones Using a Chest Strap Transmitter To use a chest strap transmitterInterfere with pacemakers or other Heart rate strapUsing the Treadmill Safety Clip Restart switchAttaching the safety clip Treadmill Auto Stop Automatic Stop Function Starting a Workout WORKOUT, Press QUICKSTART, or Enter to BeginStarting a Preset Programmed Workout Setting OptionsTo choose a language setting before you begin exercising To choose a workout goal before you begin exercisingTo enter your Age and Weight during a workout Setting Options after You Begin a WorkoutTo choose a unit of measure before you begin exercising Paused Externally Powered Equipment Pausing and Resuming an Exercise SessionPending Shutdown Self-Powered Equipment Ending a Session Operating and Maintaining the P30 Console Programs ManualHeart Rate IntervalVariety Weight LossPerformance Cleaning the Console and Display To remove dust and dirt from the console20031 142nd Avenue NE January Box Woodinville, WA USA