Assembly

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key	and your own phillips screwdriver	(with a
shaft at least 6" long) and wire cutters	.

Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled.

Extension Leg Nut (67)–4	Star Washer (8)–4	3/4" Screw (3)–12	1" Tek Screw (22)–4
Console Bolt (64)–4		Extension Leg Bolt (65)–4

1. Make sure that the power cord is unplugged.	1
	1
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the		65
Frame (58) so the treadmill is more stable. Do not fully		65
Frame (58) so the treadmill is more stable. Do not fully		84
fold the Frame until the treadmill is completely as-
sembled.		89
		89
See drawing 1a. You must attach the right and left
Extension Legs (89) on the correct sides of the treadmill.
The head of one Wheel Bolt (81) must be on the right side		67
of the right Extension Leg, and the head of the other Wheel		67
of the right Extension Leg, and the head of the other Wheel
Bolt must be on the left side of the left Extension Leg.
Note: If the heads of both Wheel Bolts (81) are on the		58
Note: If the heads of both Wheel Bolts (81) are on the
same sides of both Extension Legs (89), you must re-	1a	Left
move one of the Wheel Bolts and insert it from the oppo-	1a	Left
move one of the Wheel Bolts and insert it from the oppo-		Extension Leg
site side.		Extension Leg
site side.		(89)
		(89)
Insert the right Extension Leg into the base of the		81
Uprights (84) as shown. Next, hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg. Insert two
Extension Leg Bolts (65) into the top of the Extension			Right
Leg, and firmly tighten the Extension Leg Bolts into the			Right
Leg, and firmly tighten the Extension Leg Bolts into the			Extension Leg
Extension Leg Nuts.		81	(89)
		81

ASSEMBLY

shaft at least 6" long) and wire cutters

1. Make sure that the power cord is unplugged.

fold the Frame until the treadmill is completely as-

sembled.