2. Insert the excess Wire Harness (22, 61) down into the | 2 | Console |
|
right Upright (99). |
| ||
|
| ||
|
| Assembly |
|
Set the console assembly on the Uprights (99). While a |
|
|
|
second person holds the console assembly, attach the |
|
|
|
console assembly with four Console Bolts (86) and four |
|
|
|
Star Washers (88) as shown. Start all four Console |
|
|
|
Bolts and then firmly tighten them. |
|
|
|
|
| 22, 61 |
|
|
| 88 | 88 |
|
| 86 | 86 |
|
| 99 | 99 |
|
|
| |
3. Insert a Wheel (93) into a Wheel Housing (43). Attach the | 3 |
|
|
Wheel with a Wheel Bolt (92) and a Nut (25). Note: Do |
|
| |
|
|
| |
not overtighten the Nut; the Wheel should turn freely. |
|
|
|
Next, tip the Uprights (99) forward slightly, and insert a |
|
| 99 |
|
|
| |
Wheel Housing (43) into the base of one of the Uprights |
|
|
|
as shown. |
|
|
|
Attach the other Wheel (not shown) and Wheel Housing |
| 25 |
|
(not shown) as described above. |
|
| |
|
|
| 43 |
|
| 93 | 92 |
|
|
| |
4. With the help of a second person, carefully lower the | 4 |
|
|
Uprights (99). Make sure that the Wheel Housings (43) |
|
| |
|
| 98 | |
remain in the bases of the Uprights. |
|
| |
|
| 99 | 97 |
|
|
| |
Attach each Wheel Housing (43) with a 1” Tek Screw (98). |
|
|
|
Attach a Base Pad (97) to the base of each Upright (99) |
|
|
|
with a 1” Tek Screw (98). |
|
|
|
With the help of a second person, carefully raise the |
|
| 98 |
|
|
| |
Uprights (99) back to the vertical position. |
| 43 |
|
|
|
|
7