Assembly, Driver and rubber mallet | ProForm PFTL99602 instruction

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own phillips screw-

driver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the	1
Uprights (64) to the position as shown.	1
Uprights (64) to the position as shown.		64
		64

Insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is on the bottom. If necessary, tip the Uprights (64) forward as you insert the Extension Leg.

Insert the other Extension Leg (not shown) in the same way.

			102
			99
2. With the help of a second person, carefully lower the	2
treadmill frame and then tip the Uprights (69) down as	2
treadmill frame and then tip the Uprights (69) down as
shown. Make sure that the Extension Legs (102) remain
in the Uprights.
Attach each Extension Leg (102) with two of the six 3/4”		99
Attach each Extension Leg (102) with two of the six 3/4”
Screws (100) as shown.		Frame
With the help of a second person, carefully tip the			69
Uprights (69) back to the vertical position.			69
	69		100
Note: One replacement Base Pad (99) may be included.	69		102
Note: One replacement Base Pad (99) may be included.			102
Use the extra Base Pad if one becomes worn or needs to	99	100
be replaced.	99	100
be replaced.		102
		102
3. Insert a Handrail Extension (66) into the post on the right	3
Upright (69) as shown; make sure that the indicated holes	3
Upright (69) as shown; make sure that the indicated holes		76
are on top. Tap the Handrail Extension with a rubber mallet		76	81
to fully insert it. Attach the Handrail Extension with two 1/2”		Tab	81
			67
Screws (67) as shown.			67
Screws (67) as shown.

Holes

Identify the Right Foam Grip (75), which has a large cutout	Cutout
Identify the Right Foam Grip (75), which has a large cutout
in the left side for the Pulse Bar (76). Slide the Right Foam	75	69
Grip as far as possible onto the post on the right Upright	75
Grip as far as possible onto the post on the right Upright		Post
(69). (Note: It may be helpful to apply soapy water to the	66	Post
Handrail Extension [66].) Make sure that the tab on the
Foam Grip is inserted into the Console Base (81).