Press the On/Off button again and add or
3 delete channels.
After all valid channels available in your area have been saved into the television’s memory (see step 5 below), you can manually add channels or delete unwanted channels.
To add or delete a channel, first press the Channel buttons until the desired channel number appears on the screen. Then, press the Volume increase button to add the channel, or the Volume decrease button to delete the channel. Continue this process until you have added all desired channels and deleted all unwanted channels.
Press the On/Off button again and select an
4 antenna connection or a cable connection.
After the On/Off button is pressed, press the Volume decrease button to select the Air setting, the Volume increase button to select the Standard Cable setting, the Channel decrease button to se- lect the Cable IRC setting, or the Channel in- crease button to select the Cable HRC setting. Note: The setting that you select will not appear on the screen. If you have connected an antenna to the treadmill, the Air setting should be selected. If you have connected a CATV cable, one of the three Cable settings should be selected; try all three Cable settings, if necessary, to find the best setting.
Press the On/Off button again and save
5 channels into the television’s memory.
When the On/Off button is pressed, the television will begin scanning all of the channels available in
your area. When no broadcast signal is detected on a channel, the channel will be skipped. When a broadcast signal is detected, the channel will be saved into memory and the next channel will be selected. This process will continue until the high- est channel is reached. Do not remove the key while the television is scanning channels.
When you are finished using the information
6 mode, remove the key.
To exit the information mode at any time (except while the television is scanning channels), remove the key from the console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor provides
23