ProForm PFTL91105.0 user manual Assembly, Make sure that the power cord is unplugged

Page 7

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver

and

wire cutters

.

 

Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.

Extension Leg Nut (67)–4

Star Washer (8)–8

1” Tek Screw (22)–4

Console Bolt (64)–4

Extension Leg Bolt (65)–4

1.Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (58) so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.

Attach four Base Pads (82) (only two are shown) to the base of the Uprights (84) with four 1” Tek Screws (22).

Insert an Extension Leg (89) into the base of the Uprights (84) as shown. Hold two Extension Leg Nuts (67) in the bottom of the Extension Leg. Next, insert two Extension Leg Bolts (65) with Star Washers (8) into the top of the Extension Leg, and firmly tighten the Extension Leg Bolts into the Extension Leg Nuts.

With the help of a second person, carefully tip the tread- mill onto its other side. Attach the other Extension Leg (not shown) as described above.

1

 

 

 

 

84

65

 

 

8

82

82

 

 

89

 

 

 

 

22

 

 

67

58

 

 

7

Image 7
Contents Model No. PFTL91105.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Power Lines Back Right Side Before YOU BeginMake sure that the power cord is unplugged AssemblyBolts and then firmly tighten them Knob Spring Collar Pin Bracket Cylinder Holes Ohm Antenna HOW to Connect a 75 OHM Catv Cable HOW to Connect AN AntennaHOW to Connect a VCR HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerTurn on the fan if desired Measure your heart rate if desiredSelect a preset program HOW to USE a Preset ProgramFollow your progress with the displays Put on the chest pulse sensor HOW to USE a Heart Rate ProgramSelect a heart rate program Follow your progress with the displays Select a custom program HOW to Create a Custom ProgramHOW to USE a Custom Program Turn on the television HOW to Operate the Personal TelevisionPress the Volume VOL. buttons to adjust HOW to USE the Information ModeOptional Chest Pulse Sensor Press the On/Off button again and add or Delete channelsHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Top Problem Television reception is poor Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Qty Description R0506AExploded DRAWING-Model No. PFTL91105.0 104 67 82 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT