HOW TO TURN ON THE POWER
Plug in the power cord (see page 12).
Next, locate the reset/off |
|
|
|
|
|
|
|
|
|
| |
circuit breaker near the |
|
|
|
|
|
power cord. Make sure that |
|
|
|
|
|
| Reset | ||||
|
|
|
| ||
the circuit breaker is in the |
| Position |
|
|
|
reset position. |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 13) and attach the clip securely to the waistband of your clothes. Then, insert the key into the console. After a moment, the displays will light, and after a few sec- onds, the television will turn on. Important: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.
HOW TO USE THE MANUAL MODE
1 Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2 Select the manual mode.
When the key is inserted, the manual mode will be se- lected. If you have selected a program, reselect the manual mode by pressing the Programs (PRGM.) but- ton repeatedly until a track appears in the left display.
3 Start the walking belt.
To start the walking belt, press the Start button, the Speed increase button, or one of the twelve numbered Speed buttons.
If the Start button or the Speed increase button is pressed, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: After the buttons are pressed, it may take a moment for the walking belt to reach the selected speed setting.
If one of the numbered Speed buttons is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting.
To stop the walking belt, press the Stop button. The time will begin to flash in the left display. To restart the walking belt, press the Start button, the Speed increase button, or one of the numbered Speed buttons.
4 Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the Incline buttons. Each time a button is pressed, the incline will change by 0.5%. To change the incline setting quickly, press the numbered Incline buttons. Note: After the buttons are pressed, it may take a moment for the treadmill to reach the selected in- cline setting.
5 Follow your progress with the two displays.
The left
When the manual mode is selected, the left display will also show a track. As you exercise, the indica- tors around the track will appear in succession until the entire track appears. The track will then disappear the indicators will again begin to appear in succession.
14