ProForm PFTL79506.0 user manual Assembly, Shaft at least 6 long and wire cutters

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key	and your own phillips screwdriver	(with a
shaft at least 6" long) and wire cutters	.

Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.

3/4” Screw (22)–4	Ground Screw		Screw (3)–9
		(33)–1	Upper Latch Shock Bolt (50)–1
Extension Leg Nut (67)–4			Lower Latch Shock Bolt (39)–1
			Nut (30)–2
			Extension Leg Bolt (65)–4
Star Washer (8)–4
			Handrail Bolt (64)–4

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip		84
the treadmill onto its left side as shown.
	65
Insert an Extension Leg (89) into the base of the			82
Uprights (84) as shown. Hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg.
Next, insert two Extension Leg Bolts (65) into the		82	22
top of the Extension Leg, and firmly tighten the
Extension Leg Bolts into the Extension Leg Nuts.
Attach two Base Pads (82) to the base of the	89	22
		67
Uprights (84) with two 3/4” Tek Screws (22).
	6