ProForm PFTL79506.0 user manual Pull on the sleeve to make sure it is locked Into place

2. With the help of a second person, carefully tip	2
the treadmill onto its right side as shown.
Insert the other Extension Leg (89) into the base	84
					65
of the Uprights (84) as shown. Hold two
	22
Extension Leg Nuts (67) in the bottom of the
Extension Leg. Next, insert two Extension Leg	82		22
Bolts (65) into the top of the Extension Leg, and
firmly tighten the Extension Leg Bolts into the
Extension Leg Nuts.					58
Attach two Base Pads (82) to the base of the			67	89
Uprights (84) with two 3/4” Tek Screws (22).
With the help of a second person, carefully raise
the treadmill so that all four Base Pads (22) are
on the floor and the Frame (58) is in a vertical
position (see drawing 3).
3. Make sure that the sleeve has been slid over	3
hole 1 and that the latch knob is locked into hole
1. Pull on the sleeve to make sure it is locked
into place.
Next, make sure that the latch knob is locked	Hole 2
into hole 2. If it is not, pull out the tube until you				Latch Knob
see hole 2 and then slide the tube back in until
the latch knob locks into hole 2.	Tube				Hole 1
		Sleeve
4. Remove the plastic ties from the ends of the	4		58
Latch Shock (69).
Hold the Latch Shock (29) with the large barrel
and latch knob positioned as shown; make sure	30			50
all of the holes are aligned (see the inset draw-
					Top
ings). Next, attach the lower end of the Latch
Shock to the bracket on the Upright (84) with the					Holes
Lower Latch Shock Bolt (39) and a Nut (30).	Latch Knob			29
Then, attach the upper end of the Latch Shock
(29) to the bracket on the Frame (58) with the				Large
Upper Latch Shock Bolt (50) and a Nut (30).
				Barrel
Note: It may be necessary to move the Frame
				84
back and forth to align the Latch Shock with the
Bracket.					Holes
	30				Bottom
			39
	7