ProForm PFTL89200 specification

4.Slide the upper end of a Handrail (85) and then the Extension Leg (103) into the right Upright (82) as shown. (Note: It may be helpful to tip the Uprights [82] forward as you insert the Extension Leg.)

Slide the other Handrail (85) and Extension Leg (not shown) into the left Upright (82) as described above.

5.With the help of a second person, carefully tip the Uprights (82) down as shown. Make sure that the Extension

Legs (103) and Handrails (85) remain in the Uprights.

Next, attach each Extension Leg (103) with two Screws

(101)and a Base Pad (116) as shown. You may need to push down or tap on the top of the Uprights (82) with a rubber mallet to fully insert the Extension Legs.

Tighten the Handrail Bolts (78).

Note: One replacement Base Pad (97) may be included. Use the extra Base Pad if one becomes worn or needs to be replaced.

With the help of a second person, carefully tip the Uprights (82) back to the upright position.

6.Refer to drawing 6a. Locate the left Rear Foot (59) on the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left Rear Foot and the floor, follow the instructions below.

Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 19.

Refer to drawing 6b. Using a phillips screwdriver, remove the Screw (60), the right Rear Foot (59), and the Rear Foot Spacer (136) from the treadmill. Reattach the right Rear Foot without the Rear Foot Spacer. Hold the tread- mill with both hands, and lower the treadmill as described on page 19.

Check the left Rear Foot (59 [see drawing 6a]). If the left Rear Foot is still off the floor, raise the treadmill and re- move the left Rear Foot. Snap the Rear Foot Spacer (136) onto the left Rear Foot and reattach the left Rear Foot. Carefully lower the treadmill.

4	85
			85
	82
					82
					103
5			97
					82
					116
					101
				85	78
	82			85
	82		116		97
				103	97
				103
85			101
85
	103	78
	103		97
			97
6a
	59
6b
	60	59
		59	136
			136

7.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill.

4	85
			85
	82
					82
					103
5			97
					82
					116
					101
				85	78
	82			85
	82		116		97
				103	97
				103
85			101
85
	103	78
	103		97
			97
6a
	59
6b
	60	59
		59	136
			136

4	85
			85
	82
					82
					103
5			97
					82
					116
					101
				85	78
	82			85
	82		116		97
				103	97
				103
85			101
85
	103	78
	103		97
			97
6a
	59
6b
	60	59
		59	136
			136

4	85
			85
	82
					82
					103
5			97
					82
					116
					101
				85	78
	82			85
	82		116		97
				103	97
				103
85			101
85
	103	78
	103		97
			97
6a
	59
6b
	60	59
		59	136
			136