ProForm PFTL57807.0 user manual That no wires are pinched, Tighten all four Bolts

10. Remove the plastic ties from the Right Handrail	10
(90) and the Left Handrail (not shown). If neces-			Console Assembly
sary, press the Cage Nuts (38) into place.
Have a second person hold the console assem-
bly near the Right Upright (78). Remove the long
tie from the Upright Wire (77) and the tie from the
console wire.
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and		38
try again. IF THE CONNECTORS ARE NOT			90
	Plastic
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS		Ties	Console	Console
TURNED ON. Then, insert the connectors into		77	Wire	Wire
the Right Upright (78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make sure
that no wires are pinched.			Long	77
		78	Tie
11. Finger tighten two M8 x 25mm Bolts (6) with two	11
M8 Star Washers (10) into the Left Upright (73)
and the Left Handrail (89).
Next, finger tighten two M8 x 25mm Bolts (6)				110
					111
with two M8 Star Washers (10) into the Right
Upright (78) and the Right Handrail (90). Then,
tighten all four Bolts.			88
See steps 4 and 6. Tighten the M10 x 96mm
Bolts (5).	89
Press the Left Accessory Tray (110) and the
Right Accessory Tray (111) into the Console			6
Base (88).
			10
	6	10
			73	90
					6
					10
					78
				6	10
	11