4.Slide the upper end of a Handrail (85) and then the Extension Leg (103) into the right Upright (82) as shown. (Note: It may be helpful to tip the Uprights [82] forward as you insert the Extension Leg. If necessary, tap the Extension Leg with a rubber mallet to fully insert it.)
Slide the other Handrail (85) into the left Upright (82) as described above.
5.With the help of a second person, carefully tip the Uprights (82) down as shown. Make sure that the Extension
Legs (103) and Handrails (85) remain in the Uprights.
Next, attach each Extension Leg (103) with two Screws
(101)and a Base Pad (116) as shown in drawing 5. Make sure that the Extension Legs are fully inserted into the Uprights (82) and push down on the Uprights as you tighten the Screws.
Note: One replacement Base Pad (116) and Spacer (not shown) are included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad. If a Thick Base Pad (97) needs to be replaced, use the re- placement Base Pad with the Spacer.
With the help of a second person, carefully tip the Uprights (82) back to the upright position.
6.Refer to drawing 6a. Locate the left Rear Foot (59) on the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left Rear Foot and the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 18.
Refer to drawing 6b. Using a phillips screwdriver, remove the Screw (60), the right Rear Foot (59), and the Rear Foot Spacer (114) from the treadmill. Reattach the right Rear Foot without the Rear Foot Spacer. Hold the tread- mill with both hands, and lower the treadmill as described on page 19.
Check the left Rear Foot (59 [see drawing 6a]). If the left Rear Foot is still off the floor, raise the treadmill and re- move the left Rear Foot. Snap the Rear Foot Spacer (122) onto the left Rear Foot and reattach the left Rear Foot. Carefully lower the treadmill.
4 |
|
|
|
|
85 |
|
| 85 |
|
|
|
|
| |
82 |
|
|
| 82 |
|
|
|
| 103 |
5 |
| 97 |
| |
|
|
| ||
|
|
|
| 82 |
|
|
|
| 116 |
|
|
|
| 101 |
|
|
|
| 103 |
82 |
|
| 85 | 36 78 |
| 116 |
| ||
103 |
|
| 97 | |
| 101 |
| ||
|
|
| ||
|
|
|
| |
85 |
| 36 |
|
|
|
|
|
| |
97 |
| 78 |
|
|
6a |
|
|
|
|
59 |
|
|
|
|
6b |
|
|
|
|
60 | 59 |
|
|
|
| 122 |
|
| |
|
|
|
| |
7.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill.
7