HOW to Turn on the Power

1 Plug in the power cord (see page 10).

speed of the walking belt as desired by pressing the Speed + and – but- tons. Each time a button is pressed, the speed setting will change by

Locate the reset/off

2 circuit breaker on the

treadmill near the power cord. Make sure that the circuit breaker is in the reset position.

Reset Position

0.1mph; if a button is held down, the speed set- ting will change in increments of 0.5 mph. To change the speed setting quickly, press the Quick Speed buttons.

To stop the walking belt, press the Stop button. The Pace/Time display will begin to flash. To restart the walking belt, press the Start button or the Speed + button.

Stand on the foot rails of the treadmill. Find the clip

3 attached to the key (see the drawing on page 11) and slide the clip onto the waistband of your clothes. Next, route the cord attached to the clip under the handgrip pulse sensor, and insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.

HOW TO USE THE MANUAL MODE

1 Insert the key fully into the console.

See HOW TO TURN ON THE POWER above.

2 Select the manual mode.

When the key is in- serted, the manual mode will be selected and the indicator on the Manual Control button will light. If you have se-

lected a program, press the Manual Control button to reselect the manual mode.

Press the Start button or the Speed + button to

3 start the walking belt.

A moment after the button is pressed, the walking belt will begin to move at 1 mph. Hold the handrails and begin walking. As you exercise, change the

Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 28).

4 Change the incline of the treadmill as desired.

To change the incline of the treadmill, press the Incline buttons. Each time a button is pressed, the incline will change by 0.5%.

Follow your progress with the matrix and the

5 displays.

The matrix—When the manual mode or the iFIT.com mode is se- lected, the matrix will display a 1/4-mile track. As you exercise, the in-

dicators around the track

will light in succession until the entire track is lit. The track will then darken and the indicators will again begin to light in succession.

Incline/Heart Rate

display—This display shows the incline level of the treadmill. This display will also show your heart

rate when you use the

handgrip pulse sensor or the optional chest pulse sensor.