ProForm PFTL61931 specification

2.With the help of a second person, carefully lower the Uprights (82) as shown. Note: It may be helpful to place your foot on one of the Wheels (108) as you tip the Uprights. Make sure that the Extension Legs (106) re- main in the Uprights.

Attach each Extension Leg (106) with two 1” Tek Screws (25) and a Base Pad (100) as shown. Note: Attach the lower Tek Screw (without the Base Pad) first.

Note: One replacement Base Pad (100) may be in- cluded. If a Base Pad becomes worn and needs to be re- placed, use the replacement Base Pad.

With the help of a second person, carefully tip the Uprights (82) back to the vertical position.

3.With the help of a second person, hold the Console Base (85) near the Uprights (82) as shown.

Connect the Wire Harness (83) to the wire harness in the Right Handrail Bracket (113). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and then try again. IF THE CONNECTORS ARE NOT CONNECTED

PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the wire harnesses into the right Upright (82).

Hold the Handrail Brackets (73, 113) on top of the Uprights (82). Finger tighten two 1” Bolts (71) with Internal Star Washers (72) into the Handrail Brackets and the Uprights. Press the Handrail Brackets to- wards the center of the treadmill. Then, tighten both Bolts.

4.Attach the Storage Latch (76) to the left Upright (82) with two 3/4” Screws (6). Make sure that the large hole in the Storage Latch is on the side shown.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Insert the pin into the Storage Latch (76), and then tighten the knob back onto the pin.

2
			100
		106	25
			25
82	100
106		25
106
	108
3
71
72
73		85
	82	71
	82
		72
			83
		113
		82
		83
4
Knob

Large

Hole 6

Collar

Spring