3Install the Line Card
The R200 Premise Service Platform supports one
Before installing any card, note the following:
•Remove the temporary slot protector by turning the thumb screw counterclockwise and removing the blank panel.
•Set all switches and/or jumpers on the line card. Refer to the card’s documentation for a complete description of its settings.
Follow the simple steps outlined below to install the line card:
•Grasp the card by the front panel as shown (thumb screw to the left).
•Line the edges of the board with the slot guides and slide the card in until the edges are flush and even with the front of the unit. Do not force the card into the slot. It should slide in easily and evenly.
•Secure to the R200 by turning the thumb screw clockwise until snug. The line card is now ready for connection to the network.
|
|
| S M |
| x II |
|
|
| FX |
|
|
|
|
|
|
DIS | LBK | LK | RX | DIS | LBK | LK | RX |
Card Guide
MAN | 100 |
FD PWR | BASE |
6 Installation Guide
