2.Identify the Right Handrail (72), which has a large hole in the left side. Feed the Upright Wire (42) into the hole in the bottom of the Right Handrail and out of the large hole in the side. Note: It may be helpful to use needlenose pli- ers to pull the Wire Harness out of the hole.
Attach the upper end of the Right Handrail (72) to the right Upright (69) with a 3” Bolt (37). Do not tighten the Bolt yet. Attach the lower end of the Right Handrail with a Handrail Bolt (98) and a Star Washer (101). Tighten both Bolts; be careful not to overtighten the Handrail Bolt.
Attach the upper end of the Left Handrail (71) to the left Upright (69) with a 3” Bolt (37). Do not tighten the Bolt yet. Attach the lower end of the Left Handrail with a Handrail Bolt (98) and a Star Washer (101). Tighten both Bolts; be careful not to overtighten the Handrail Bolt. Note: There is not a wire harness on the left side.
3.With the help of another person, carefully lower the Uprights (69) as shown. Note: It may be helpful to place one foot on one of the Extension Legs (63) as you tip the Uprights. Make sure that the Extension Legs remain in the Uprights.
Attach each Extension Leg (63) with two 1” Tek Screws
(39)and a Base Pad (57) as shown. Attach the lower
Tek Screw, without the Base Pad, first.
Attach two Base Pads (57) to the base of the Uprights (69) with two 1” Tek Screws (39).
Attach the two Wheels (66) with two Wheel Bolts (64) and two Wheel Nuts (32) as shown. Do not overtighten the Bolts; the Wheels should be able to turn freely.
With the help of another person, carefully raise the Uprights (69) to the vertical position.
2 |
|
|
|
| 71 |
|
|
37 |
| 72 |
|
|
|
| |
| 42 | Hole |
|
| 37 |
|
|
| 69 |
| Hole |
|
|
| |
|
|
| 69 |
98 |
|
|
|
101 |
|
|
|
| 98 |
|
|
| 101 |
|
|
3 | 69 | 66 | 64 |
|
|
| 39 |
|
| 32 | 57 |
|
| 57 | |
| 66 |
| |
|
|
| |
64 | 32 |
|
|
| 57 |
| 39 |
| 39 | 63 | |
|
| ||
|
|
| |
69 | 57 |
|
|
39 |
|
| |
|
|
| |
63 |
|
|
|
7