ProForm PFTL591040 user manual

5.Identify the Right Handrail (120) and the Left Handrail (108) (there is an identification sticker on each Handrail). Hold the Right Handrail near the Right Upright (119). Insert the Wire Harness (118) into the large hole in the Right Handrail and out of the upper end as shown.

Next, hold the Right Handrail (120) against the Right Upright (119). Tighten a 4” Bolt (121) three to four turns into the Right Upright and the lower end of the Right Handrail. Then, tighten two 5/16” x 1” Bolts (113) into the upper end of the Right Handrail and the Right Upright. Be careful not to drop the Bolts into the Handrail. If nec- essary, raise or lower the Handrail to thread the 5/16” x 1” Bolts into the Upright. Firmly tighten all three Bolts.

Attach the Left Handrail (108) to the Left Upright (111) as described above. Note: There is not a wire harness in the Left Upright.

6.Turn the Console (101) upside-down; be careful not to scratch the Console. Remove the bands and the Console Back (104) (see drawing 6) from the Console. If the four Pulse Bar Screws (76) (only two are shown) are in the Console Frame (80), remove them.

Hold the ends of the Pulse Bar (77) against the Console Frame (80) as shown. Connect the pulse wire in the Console (101) to the pulse wire in the Pulse Bar (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one con- nector and try again to connect them. Attach the Pulse Bar to the Console Frame with the four Pulse Bar Screws

(76).Firmly tighten the Pulse Bar Screws. Be careful not to damage the wires.

Attach the ring on the ground wire to the Console Frame

(80)with a 1/2” Ground Screw (52). Note: There are no wires on the other side of the Pulse Bar (77).

7.Attach the Console Back (104) to the console assembly with five 3/4” Screws (33).