3.Slide the upper end of a Handrail (85) into the right Upright (82) as shown. Note: It will be necessary to pivot the Handrail to the side and back repeatedly (see arrow A) while pushing on the Handrail (see arrow B) to slide it fully into the Upright. Next, pivot the lower end of the Handrail down, push it toward the right Upright, and then align it with the indicated hole.
Slide the other Handrail (85) into the left Upright (82) as described above.
4.With the help of a second person, carefully tip the Uprights (82) down as shown. Make sure that the
Extension Legs (103) remain in the Uprights.
Insert a Handrail Bolt (78) with a Handrail Washer (36) into each Extension Leg (103), and tighten the Handrail Bolts into the Handrails (85). Note: If it is difficult to thread the Bolts into the Handrails, pull one of the Handrails to the side and hand tighten a Bolt into the bottom of the Handrail. Notice the angle of the Bolt. When attaching the Handrails to the Extension Legs, insert the Bolts and Washers at the observed angle. It should be close to the same angle as the Handrails (see drawing 4b).
Refer to drawing 4c. If it is difficult to align the hole in a Handrail (85) with the hole in an Extension Leg (103), it may be necessary to move the Handrail up or down or have a second person stand on the treadmill and lift the Handrail.
Refer to drawing 4a. Attach each Extension Leg (103) with two Screws (101) and a Base Pad (116) as shown.
Note: One replacement Base Pad (116) and Spacer (not shown) are included. If a Base Pad (116) becomes worn and needs to be replaced, use the replacement Base Pad. If a Thick Base Pad (97) needs to be replaced, use the replacement Base Pad with the Spacer.
With the help of a second person, carefully tip the Uprights (82) back to the upright position.
3 |
|
|
| |
| 85 | B |
| |
|
|
| ||
| 82 |
| 82 | |
85 |
|
|
| |
|
| A |
| |
|
|
| Hole | |
4a | 97 |
|
| |
|
|
| 82 | |
82 |
|
| 116 | |
|
|
| ||
|
|
| 101 | |
|
|
| 36 | |
82 |
| 85 |
| |
116 | 103 | 97 78 | ||
85 | ||||
101 | 4b | 78 | ||
103 | ||||
36 |
| |||
|
|
| ||
| 78 | 85 | 36 | |
| 97 | |||
| 103 |
| ||
|
|
| ||
4c |
|
|
| |
| 85 |
|
| |
| 103 |
|
|
5.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet from damage, place a mat under the treadmill.
7