GETTING STARTED
Before operating the con- sole, make sure that the
on/off switch near the power cord is in the on
position. Next, make sure that the key is removed
from the console and the power cord is properly plugged in (see HOW TO PLUG IN THE POWER CORD on page 8).
When you are ready to begin exercising, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 9), and slide the clip onto the waistband of your clothing. Next, insert the key fully into the console. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.
To use the manual mode, follow the steps below and on page 11. To use iFIT.com CD or video programs, refer to page 14. To use iFIT.com programs directly from our internet site, see page 16.
Note: The console can display speed and distance in either miles or kilometers (see SPEED DISPLAY on page 11). For simplicity, all instructions in this manual refer to miles.
HOW TO USE THE MANUAL MODE
1Insert the key fully into the console.
When the key is inserted, the four dis- plays and various indi- cators on the console will light.
2Select the manual mode.
When the key is in- serted, the manual
mode will automatically be selected, as shown
by the MANUAL CON-
TROL indicator. If the iFIT.com indicator is lit,
press the PROGRAM button to select the manual mode.
Press the START button or the SPEED ▲ button
3 to start the walking belt.
A moment after the button is pressed, the walking belt will begin to move at 1 mph. Hold the hand- rails and carefully begin walking. As you exercise, change the speed of the
walking belt as desired by pressing the SPEED ▲
and ▼ buttons. To change the speed setting quickly,
press the QUICK SPEED buttons. Note: After the
buttons are pressed, it will take a moment for the walking belt to reach the selected speed setting.
To stop the walking belt, press the STOP button. The TIME/INCLINE display will begin to flash. To restart the walking belt, press the START button or the SPEED ▲ button.
4Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
INCLINE buttons. Each time a button is pressed,
the incline will change by 0.5%. The buttons can be
held down to change the incline rapidly. Note: After the INCLINE buttons are pressed, it will take a moment for the treadmill to reach the selected incline setting.
5 | Follow your progress | with the LED track and |
the four displays. |
| |
|
|
The LED TrackÑ The LED track represents a dis- tance of 1/4 mile. As you exercise, the indicators around the track will light one at a
time until you have walked or run 1/4 mile. A new | ||
lap will then begin. |
|
|
DISTANCE/LAPS dis- |
|
|
|
| |
Arrow |
| |
playÑThis display shows |
| |
|
| |
the distance that you |
|
|
have walked or run and |
|
|
the number of laps you |
|
|
|
| |
have completed (one lap |
|
|
equals 1/4 mile). The display will alternate |
between one number and the other every seven seconds, as shown by the arrows in the display.
10