ProForm PFTL58007.1 user manual Start all the Screws before tightening any of them

Page 10

10.With the help of a second person, hold the con- sole assembly near the Right Handrail (34) and the Left Handrail (not shown).

Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-

NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Insert the connectors and the excess wire into the Right Handrail (34).

11.Connect the console ground wire to the handrail ground wire.

Set the console assembly on the Right Handrail

(34)and the Left Handrail (33). Make sure that the wire harnesses are not pinched. Attach the console assembly with ten #8 x 3/4" Screws

(12).Start all the Screws before tightening any of them.

Cut the plastic tie off the Right Handrail (34).

See steps 4 and 6. Firmly tighten the four 3/8" x 4" Bolts (6).

10

 

Console

Console

Wire

Assembly

38

 

34

 

 

Console

 

Wire

 

38

11

 

Console Assembly

33

Ground Wires

12

Plastic

12

 

Tie

12

 

12

34

12

12

 

12.Identify the Storage Latch (53). Remove the tie from the end of the tube. Make sure that the sleeve has been slid over the indicated hole and that the Latch Knob (54) is locked into the hole.

Pull on the sleeve to make sure that it is locked into place.

12

 

54

Tube

Hole

 

Sleeve

53

10

Image 10
Contents Call TOLL-FREE QUESTIONS?Please do not Contact On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Hardware may be includedNut the Wheel must turn freely. Discard Make sure that the power cord is unpluggedDo not fully fold the Frame yet See the inset drawing. Tie the long tieFully tighten the Bolts yet Make sure the Upright Wire 38 is notNot fully fold the Frame yet Firmly tighten the Bolts Star Washers 9. Firmly tighten the BoltsStart all the Screws before tightening any of them Pull on the sleeve to make sure that it is locked into placeRaise the Frame 56 to the position shown HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired HOW to USE a Classic Workout Select a classic workoutHOW to USE the Weight Loss Center Select a weight loss workoutInformation Mode HOW to USE the Stereo Sound SystemConnector is fully plugged Optional Chest Pulse SensorHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Page Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R1107A Qty DescriptionQty Exploded Drawing A-Model No. PFTL58007.1 R1107A Exploded Drawing B-Model No. PFTL58007.1 R1107A Exploded Drawing C-Model No. PFTL58007.1 Exploded Drawing D-Model No. PFTL58007.1 R1107A Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT