ProForm 995 Make sure that the power cord is unplugged, See the inset drawing. Tie the wire tie

1.

Make sure that the power cord is unplugged.

1

Place a piece of cardboard below the rear of the

Frame (56) to protect the floor or carpet.

Attach the Left Wheel Cap (96) to the Base (94)

56

with two #8 x 3/4" Screws (2).

Attach the Right Wheel Cap (not shown) to

the right side of the Base (94) in the same

way.

94

2

96 Cardboard

2. Pull the Upright Wire (81) and the Base Ground

2

Wire (110) through the indicated hole in the

Base (94).

Attach the Base Ground Wire (110) to the Base

Hole

77

(94) with a #8 x 1/2" Ground Screw (10).

Press the Grommet (77) into the square hole in

81

the Base (94).

10

110

94

3. Identify the Left Upright (89), which is marked

3

with a “Left” sticker or an “L” sticker. Have a sec-

81

ond person hold the Left Upright near the Base

(94).

89

See the inset drawing. Tie the wire tie in the

Wire

Left Upright (89) securely around the end of the

81

Upright Wire (81). Then, pull the other end of the

Tie

wire tie until the Upright Wire is routed com-

Wire

pletely through the Left Upright.

89

Tie

81

94

7