JVC RX-DV5SL manual Press VFP, Press cursor 3 or 2 repeatedly to select VFP mode

To move the zoomed-in position

Press cursor 5/∞/3/2.

ZOOM x4

To return to normal playback

Press ENTER.

Note:

•While being zoomed in, the picture may look coarse.

7Changing the VFP setting—VFP

The VFP (Video Fine Processor) function enables you to

adjust the picture based on the picture tone, or personal preference.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•Before using the remote control, press DVD to change the remote control operation mode.

SUBTITLE SURR MODE	– SUBWOOFER +
10/0	+10	VFP
	100+	TV RETURN
DIMMER		PROGRESSIVE
ANGLE
+	+	+
PAGE MUTING TV VOL		VOLUME
ZOOM	–	–	& During playback
–
DIGEST TOP MENU		MENU
CHOICE
	ENTER
ON SCREEN		RETURN

To adjust the appearance of the picture

When selecting “USER1” or “USER2,” you can adjust the appearance of picture.

1Press VFP, then press cursor 3 (or 2) repeatedly to select “USER1” or “USER2.”

USER1

GAMMA	+0
BRIGHTNESS	+0
CONTRAST	+0
SATURATION	+0
TINT	+0
SHARPNESS	+3
Y DELAY	+0

2Press cursor ∞ (or 5) repeatedly to select a

parameter you want to adjust.

Adjust gradually to show preferable appearance by confirming the picture.

GAMMA	: Controls the brightness of neutral tints
	while maintaining the brightness of dark
	and bright portions (–4 to +4).
BRIGHTNESS : Controls the brightness of the screen
	(–16 to +16).
CONTRAST	: Controls the contrast of the screen
	(–16 to +16).

SATURATION : Controls the color depth of the screen

	(–16 to +16).
TINT	: Controls the tint of the screen
	(–16 to +16).
SHARPNESS	: Controls the sharpness of the screen
	(+0 to +3).
Y DELAY	: Controls the color gap of the screen
	(–2 to +2).

English

1Press VFP.

The current VFP setting screen appears on the TV.

NORMAL

GAMMA +0

BRIGHTNESS +0

CONTRAST +0

SATURATION +0

TINT+0

SHARPNESS +3

Y DELAY +0

Ex. : When “NORMAL” is selected

2Press cursor 3 (or 2) repeatedly to select the

VFP mode.

•Each time you press the button, the VFP mode changes as follows.

NORMAL “ CINEMA “ USER1 “ USER2 “

(back to the beginning)

NORMAL	: Normally select this.
CINEMA	: Suitable for a movie source.

USER1 and USER2 : You can adjust parameters that affect the appearance of picture and store the settings (see the right).

To turn off the VFP setting screen

Press VFP.

3Press ENTER.

The VFP setting screen disappears and the following pop-up window appears on the TV.

GAMMA +0

GAMMA +0

Ex. : When “GAMMA” is selected

4Press cursor ∞ (or 5) repeatedly to change the

setting, then press ENTER.

The current VFP setting screen appears again.

5Repeat steps 2 to 4 to adjust other parameters.

To turn off the VFP setting screen

Press VFP.

To activate your setting

Press VFP, then press cursor 3 (or 2) repeatedly to select “USER1” or “USER2.”

Note:

•The VFP setting screen disappears if no operations are done for more than about 10 seconds.

40