JVC RX-DV5SL manual Getting Started, Connecting the FM and AM Antennas, AM antenna connection

Page 8

English

Getting Started

Connecting the FM and AM Antennas

AM loop antenna

If AM reception is poor, connect an outdoor

(supplied)

single vinyl-covered wire (not supplied).

If FM reception is poor, connect outdoor FM antenna (not supplied).

Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.

B

75

FMCOAXIAL

75

FMCOAXIAL

AM LOOP

FM antenna (supplied)

FM 75

AM EXT

COAXIAL

ANTENNA

1	2	1	3	RIGHT LEFT	RIGHT	LEFT			DIGITAL IN	DIGITAL OUT
				FRONT	CENTER	REAR	SUB-
				SPEAKERS	SPEAKER	SPEAKERS	SUB-	DIGITAL 1	DIGITAL 2
							WOOFER	DIGITAL 1	DIGITAL 2
							OUT	(DBS)	(TV)
										PCM/STREAM

DBS	OUT	VCR	IN	MONITOR	DBS	OUT	VCR	IN	MONITOR
IN	(REC)		(PLAY)	OUT	IN	(REC)		(PLAY)	OUT

CAUTION:

AUDIO

SPEAKER

TV

TAPE / CDR

DBS

VCR

IMPEDANCE

8

16

LEFT

S-VIDEO

VIDEO

AM LOOP

2

RIGHT

Y

PB

PR

FM 75

AV COMPU LINK-

IN

OUT

IN

IN

OUT

IN

AM EXT

COAXIAL

(REC)

(PLAY)

(REC)

(PLAY)

DVD COMPONENT VIDEO OUT

ANTENNA

Rear panel of the unit

AM antenna connection

Connect the AM loop antenna supplied to the AM LOOP terminals.

1Remove the insulation if the AM loop antenna wire is covered with vinyl.

2Press and hold the clamp of the terminal (1), then insert the wire (2).

3Release the clamp.

Turn the loop until you have the best reception.

•If the reception is poor, connect an outdoor single vinyl- covered wire (not supplied) to the AM EXT terminal. Keep the AM loop antenna connected.

FM antenna connection

Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal as temporary measure.

Extend the supplied FM antenna horizontally.

•If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 Ω antenna with a coaxial type connector, disconnect the supplied FM antenna.

Note:

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

5

Image 8

Contents RX-DV5SL Mises en garde, précautions et indications diverses English Français Table of Contents Adjust button 23 Parts IdentificationFront Panel DisplayRemote Control Parts IdentificationGetting Started Before Installation Putting Batteries in the Remote ControlChecking the Supplied Accessories Connecting the FM and AM Antennas Getting StartedAM antenna connection FM antenna connectionConnecting the Speakers Connecting the subwoofer speakerConnecting the front, center, and rear speakers Speaker Layout DiagramConnecting Audio/Video Components About connecting cordsFor video connections For audio connectionsVideo connections Audio connectionsGreen WhiteVCR connection DBS tuner connectionVCR WhiteCD recorder Cassette deck/CD recorder connectionDigital connection Turn On the Power Adjust the VolumeBasic Operations Select the Source to PlayTurning Off the Power With the Sleep Timer Changing the Source NameInput mode On the remote controlWhen DVD is selected as the source, you can also Basic OperationsAttenuating the Input Signal Changing the Scanning ModeActivating the Recording Mode Input ATT indicatorBasic DVD Player Operations Open the Disc TrayLoad a Disc Start PlaybackSelect Surround Mode Turn Off the Power into StandbyActivate Realistic Sound Field Stop PlaybackTuning into Stations Manually Using Preset Tuning Tuner OperationsSelecting the FM Reception Mode Operation Buttons Basic SettingsOperating Procedure ¶ For subwoofer YESBasic Settings Set the appropriate digital terminal settingLow frequency effect attenuator-LFE Digital input Digital in terminals-DGTAV Compu Link Remote Control System on pages 59 Auto surround-AUTO SR Video output mode-VOUTOn the display Set the output terminal appropriatelySound Adjustments Press AdjustPress Control 3 or 2 to adjust Front speaker balance Adjustment itemsAdjusting sound from the remote control Front speaker output balance -BAL balanceTone-BASS and Treble DAP effect level-EFFECTCreating Realistic Sound Fields Dolby SurroundDTS Digital Surround DAP Digital Acoustic Processor modesPossible × Impossible All Channel StereoReflections from behind Early reflections Direct sounds Selecting Surround Modes Activating Surround ModeCreating Realistic Sound Fields Adjusting Surround Mode Using Remote Control Adjust the soundAdjust the speaker output levels as follows For using test toneDVD Player Operations Disc InformationPlayable Disc Types Discs you can play Disc TypeMenu-driven playback Disc structurePlayback Control function PBC DVD Player Operations Using the On-screen BarContents of the on-screen bar with the pull-down menu Basic Operation through the On-screen Bar Changing the Time IndicationPress on Screen twice Press EnterLocating a Desired Scene from Disc Menu Press TOP Menu or MenuFrom the DVD menu From the VCD/SVCD menu with PBCSelecting a View Angle-ANGLE Press AnglePress Angle repeatedly to select the desired view angle Press and hold Angle for a few secondsChanging the Languages-SUBTITLE Press SubtitlePress Audio Press Audio repeatedly to select the desired audio languagePress Audio repeatedly to select the desired audio channel Selecting the audio channelFor VCD For SvcdPlaying from a Specified Position on a Disc Use the number buttons 0-9 to enter the timeLocating a desired chapter/track Chapter/Track Search Locating a desired position-Time SearchLocating a desired scene-DIGEST Press DigestPress cursor 5/∞/3/2 to move to the desired scene Special Picture Playback Press cursor 3 or 2 repeatedly to select VFP mode Repeat steps 2 to 4 to adjust other parametersChanging the VFP setting-VFP To adjust the appearance of the pictureProgram Playback and Random Playback Repeat to program the next stepsPlaying back in the desired order Playing back tracks in random orderRepeating a desired part Repeat PlaybackRepeating a current title, group, chapter, or All tracks Activating Surround mode Additional Information for DVD AudioSpecial Playback for DVD Audio About indication on the front panelPress cursor ∞ or 5 repeatedly to select the desired Press the number buttons to select a bonus groupSelecting a still picture Playing back a bonus groupLoad an MP3 disc, then press MP3 Disc PlaybackBasic Operations Operations through the MP3 Control Screen Press RepeatLoad a Jpeg disc, then press Jpeg Disc PlaybackSlide-show Playback Operations through the Jpeg Control Screen Press Menu orOperation Buttons Configuration of Choice Menu Choice Menu OperationsPress Enter to finish the setting Press ChoicePress cursor 3 or 2 repeatedly To display Picture menu Press cursor ∞ or 5 repeatedly To move to ProgressivePicture menu Choice Menu OperationsLanguage menu Audio menu MP3Jpeg MAXSPK. Setting menu Others menu Select this to deactivate itSetting Parental Lock Restricting Playback by Parental LockReleasing Parental Lock temporarily Changing the setting of Parental LockNew setting is stored Country/Area codes list for Parental Lock Glossary for DVD Player AV Compu Link Remote Control System TV’s Video Input 1 terminal using S-video cablesConnections 1 AV Compu Link Connection Connections 2 Video Cable ConnectionRemote Control of the TV and VCR Using This Remote Control Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch Video PlayOperating JVC’s Audio/Video Components Operating Audio ComponentsCD recorder Sound control section AmplifierOperating Video Components STANDBY/ON VCRREW TV/VIDEOChanging the Preset Signal Codes Operating Other Manufacturers’ EquipmentRelease STANDBY/ON TV Try to operate your TV by pressingEnter the manufacturer’s code using the number buttons 1-9 Press and holdPress DBS Release STANDBY/ON DBSUsing the number buttons 1-9, 0. Test Operating Other Manufacturers’ EquipmentEnter the manufacturer’s code Release STANDBY/ON VCRMaintenance Cleaning DiscsCleaning the Unit General NotesTroubleshooting GenaralFor DVD Player Troubleshooting For TunerFor MP3 For JpegSpecifications AmplifierFM tuner IHF AM tunerVictor Company of JAPAN, Limited 0802NHMMDWJEM