3.With the help of a second person, hold the Console Base
(6) and the Right Handrail (32) near the right Upright (14) as shown. Route the Console Wire Harness (92) through the bracket on the Right Handrail.
Refer to the inset drawing. Slide the Strain Relief Clip
(88)onto the Console Wire Harness (92). Make sure that there is no slack in the Console Wire Harness between the Strain Relief Clip and the Console Base (6). Insert a 3/4Ó Screw (91) into the Strain Relief Clip and into the in- dicated hole in the Right Handrail (32). Tighten the Screw into the Console Base.
IMPORTANT: The Strain Relief Clip (88) must be attached as instructed.
4.With the help of a second person, hold the Pulse Handrail (99) near the right Upright (14) as shown. Route the 30Ó and 9Ó Pulse Wires (97, 95) through the bracket on the Right Handrail (32).
Connect the Console Wire Harness (92) to the Upright Wire Harness (96). Connect the 30Ó and 9Ó Pulse Wires (97, 95) to the Upright Wire Harness (92) as shown in the inset drawing. Make sure that the wires with tags are connected to each other.
Position the Pulse Handrail (99) between the Left and Right Handrails (2, 32) as shown. Insert all wires into the right Upright (14). Insert the bracket on the Right Handrail (32) into the right Upright (14). Make sure that the wires are not pinched.
5.Using the included allen wrench, attach the Pulse Handrail (99) to the Left and Right Handrails (2, 32) with two Pulse Handrail Bolts (98) and Handrail Washers (16).
6.Attach the Console Base (6) to the Left and Right Handrails (2, 32) with three 3/4Ó Screws (91).
6
3 |
|
|
|
6 |
|
| |
Bracket | 88 |
|
|
32 | 91 |
|
|
| 92 |
|
|
| 14 | 6 |
|
|
|
| |
|
| 32 | 88 |
|
|
| 91 |
|
|
| 92 |
4 |
|
|
|
Bracket |
|
|
|
92 |
|
|
|
| 95 |
| 99 |
32 | 96 |
| 2 |
| 97 |
| |
|
|
| |
| 14 |
|
|
| 96 |
|
|
| 97 |
| 92 |
|
|
| |
| 95 |
|
|
5 |
|
|
|
98 16 |
|
|
|
32 | 99 | 2 | 16 | 98 |
| ||||
|
|
|
| |
6 |
|
|
|
|
|
| 6 |
|
|
32 | 91 | 2 |
|
|
|
|
|
| 91 |