JVC RX-5000VBK manual Changing the Source Name, Setting Center and Rear Speakers for DSP Modes

Basic Settings

Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier.

Changing the Source Name

When you have connected an MD recorder to the TAPE/MD jacks on the rear panel: Change the source name shown on the display when you select the MD recorder as the source.

On the front panel ONLY:

When changing the source name from “TAPE” to “MD”:

		TAPE/MD
1.	Press TAPE/MD.
	• Make sure “TAPE” appears on the display.	SOURCE NAME
2.	Press and hold SOURCE NAME	TAPE/MD

(the same button as TAPE/MD)

SOURCE NAME

until “MD” appears on the display.

To change the source name from “MD” to “TAPE,” repeat the same procedure above (in step 1, make sure “MD” appears on the display).

Note:

Without changing the source name, you can still use the connected components. However, there may be some inconvenience.

–“TAPE” will appear on the display when you select the MD recorder.

–You cannot use the COMPU LINK remote control system (see page 21) to operate the MD recorder.

Setting Center and Rear Speakers for

the DSP Modes

To obtain the best possible surround sound of the DSP (Digital Signal Processor) modes (see page 15), you have to register the information about the speaker arrangement after all connections are completed.

Center Speaker Setting

Register the center speaker size.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

MULTI CURSOR

3.Press MULTI CURSOR @/ #to select your center speaker size.

LARGE SMALL NO

LARGE: Select this mode when the size of the center speaker is the same as that of the front speakers.

SMALL: Select this mode when the size of the center speaker

is smaller than that of the front speakers.

NO: Select this mode when you do not use a center speaker.

Rear Speaker Setting

Register whether you have connected the rear speakers or not.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1. Press SETTING so that the	SETTING
MULTI CURSOR %/ Þbuttons
work for setting the rear speaker
information.
	MULTI CURSOR

2. Press MULTI CURSOR %/ Þ repeatedly until “REAR SPK” (Rear Speaker) appears on the display.

MULTI CURSOR

3.Press MULTI CURSOR @/ #to register whether you have connected the rear speakers.

YES: Select this mode when you use rear speakers.

NO: Select this mode when you do not use rear speakers.

Note:

On the front panel ONLY:

1.Press SETTING so that the MULTI CURSOR %/ Þbuttons work for setting the center speaker size.

2.Press MULTI CURSOR %/ Þ repeatedly until “CNTR SPK” (Center Speaker) appears on the display.

SETTING

MULTI CURSOR

When you change your speakers, you need to register the information about the speakers again.

Delay Time Setting

Register the delay time of the sound from the rear speakers, comparing the sound from the front speakers.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You can adjust the delay time only when you have connected the rear speakers and have set “REAR SPK” to “YES’’ (See above).

•Delay time setting is only valid for ‘‘PRO LOGIC” (See page 15).

11