JVC RX-5000VBK manual Specifications, Amplifier, FM tuner IHF, AM tuner, General

Page 27

Specifications

Amplifier

Output Power

At Stereo operation: 100 watts per channel, min. RMS, driven into 8 ohms, at 40 Hz to 20 kHz with no more than 0.8 % total harmonic distortion.

At Surround operation:

Front Channel:

100 watts per channel, min. RMS, driven into

 

8 ohms at 1 kHz with no more than 0.8 % total

 

harmonic distortion.

Center channel:

100 watts, min. RMS, driven into

 

8 ohms at 1 kHz, with no more than 0.8 %

 

total harmonic distortion.

Rear channel:

50 watts per channel, min. RMS, driven into 8

 

ohms at 1 kHz, with no more than 0.8 % total

 

harmonic distortion.

Total Harmonic Distortion (8 ohms, 1 kHz):

0.8 %* at 100 watts output

(* Measured by JVC Audio Analysis System)

Audio

Audio Input Sensitivity/Impedance (1 kHz): PHONO (MM): 2.7 mV/47 k ohms CD, TAPE/MD, VCR, DVD:

220 mV/47 k ohms

Audio Output Level: TAPE/MD, VCR 220 mV

Signal-to-Noise Ratio (’66 IHF/’78 IHF):

PHONO:70 dB/77 dB (at REC OUT)

CD, TAPE/MD, VCR, DVD:

87 dB/67 dB

Frequency Response (8 ohms):

PHONO:20 Hz to 20 kHz (±1 dB) CD, TAPE/MD, VCR, DVD:

20 Hz to 20 kHz (±1 dB)

RIAA Phono Equalization: ±1.0 dB (20 Hz to 20 kHz)

Video

Video Input Sensitivity/Impedance:

VCR, DVD:

1Vp-p/75 phms

Video Output Level:

VCR, MONITOR OUT: 1Vp-p/75 ohms

Synchronization:Negative

Signal-to-Noise Ratio: 45dB

FM tuner (IHF)

Tuning Range:

87.5 MHz to 108.0 MHz

Usable Sensitivity: Monaural: 12.8 dBf (1.20 µV/75 ohms)

50 dB Quieting Sensitivity:

Monaural:

21.3 dBf (3.2 µV/75 ohms)

Stereo:

41.3 dBf (31.5 µV/75 ohms)

Signal-to-Noise Ratio (IHF-A weighted):

Monaural:

78 dB at 85 dBf

Stereo:

73 dB at 85 dBf

Total Harmonic Distortion:

Monaural:

0.4 % at 1 kHz

Stereo:

0.6 % at 1 kHz

Stereo Separation at REC OUT: 35 dB at 1 kHz

Alternate Channel Selectivity:

45 dB: (±400 kHz)

Frequency Response:30 Hz to 15 kHz: (+0.5 dB, –3 dB)

AM tuner

 

 

 

Tuning Range:

530 kHz to 1,710 kHz

Usable Sensitivity: Loop antenna

400 µV/m

Signal-to-Noise Ratio:

 

50 dB (100 mV/m)

General

 

 

 

Power Requirements:

 

AC 120V

, 60 Hz

Power Consumption:

 

290 watts/390 VA (at operation)

 

 

2 watts (in standby mode)

Dimensions (W x H x D):

435 x 146 x 403.5 mm

 

 

(17 3/16 x 5 3/4 x 15 15/16 inches)

Mass:

 

10.2 kg (22.5 lbs)

Designs & specifications are subject to change without notice.

25

Image 27
Contents RX-5000VBK For U.S.A Table of Contents To use the Cursor control buttons q on the front panel Remote ControlParts Identification Front PanelGetting Started Before InstallationConnecting the FM and AM Antennas Checking the Supplied AccessoriesConnecting the rear and center speakers Connecting the SpeakersBasic connecting procedure Connecting the front speakersIf your audio components have a Compu LINK-3 terminal Connecting Audio/Video ComponentsConnecting the subwoofer speaker Audio component connectionsVCR Video component connections+ to + and to Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletOn the front panel Turning the Power On and Off StandbyFrom the remote control Basic OperationsMuting the Sound Selecting the Front SpeakersRecording a Source Reinforcing the Bass Attenuating the Input SignalAdjusting the Front Speaker Output Balance Adjusting the ToneChanging the Source Name Setting Center and Rear Speakers for DSP ModesStoring the Basic Settings Adjustments One Touch Operation Using the Sleep TimerPress ONE Touch Operation Press FM or AM Tuning in Stations ManuallyUsing Preset Tuning Receiving Radio BroadcastsSelecting the FM Reception Mode Surround Modes Using the DSP Modes3D-PHONIC modes DAP modesSpeaker arrangements Available DSP modes Available DSP Modes According to the Speaker ArrangementAdjusting the DAP Modes Adjusting the 3D-PHONIC ModesOutput balance Press Rearl / + to adjustPress Surround repeatedly Rear speaker output levelSelect and play a sound source Press Surround repeatedly Until the DSP mode you wantTo cancel the DSP mode Activating the DSP ModesActivating the DVD Multi Playback Mode Using the DVD Multi Playback ModeAutomatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Same timeTuner Operating JVC’s Audio/Video ComponentsSound control section Amplifier Cassette deckCD player-changer MD recorderDVD player Problem Possible Cause Solution TroubleshootingAM tuner SpecificationsAmplifier FM tuner IHFHOW to Locate Your JVC Service Center Limited Warranty AUDIO-2 1299HIMMDWJEIN

RX-5000VBK specifications

The JVC RX-5000VBK is a powerful and versatile audio receiver that offers a rich set of features for both home theater enthusiasts and casual listeners. This unit is designed to deliver excellent sound quality, impressive connectivity options, and user-friendly operation.

One of the standout features of the RX-5000VBK is its ability to deliver high-fidelity audio with clarity and depth, making it an ideal choice for those who value sound quality. With an output of 100 watts per channel, this receiver can drive a variety of speakers, ensuring that users get the best possible performance whether they are enjoying music or watching movies.

The RX-5000VBK integrates advanced surround sound processing capabilities, supporting formats like Dolby Digital and DTS. This processing allows users to experience immersive audio, bringing movies and music to life in a way that's rich and engaging. The unit also includes a built-in equalizer, which allows users to customize their listening experience by adjusting bass and treble settings to their preference.

Connectivity is another strong point of the JVC RX-5000VBK. The receiver comes equipped with multiple HDMI inputs that support 4K video pass-through, enabling users to connect their favorite devices such as Blu-ray players, gaming consoles, and streaming devices without sacrificing video quality. Additionally, there are various analog and digital audio inputs, including optical and coaxial options, making it easy to connect vintage components as well.

The user interface of the RX-5000VBK is designed for simplicity, featuring an intuitive layout that makes it easy to navigate through settings and modes. The included remote control enhances this convenience, allowing users to make adjustments from the comfort of their seating area. Furthermore, the receiver features a built-in AM/FM tuner with programmable presets, enabling users to enjoy their favorite radio stations with ease.

The design of the RX-5000VBK is both stylish and functional, featuring a sleek black finish that can fit well with any home décor. The unit’s compact form factor ensures it can be integrated into various home setups without taking up too much space.

In summary, the JVC RX-5000VBK is a feature-rich audio receiver that excels in delivering high-quality sound, versatile connectivity options, and user-friendly operation. With its combination of advanced technologies and thoughtful design, it stands as an excellent choice for anyone looking to enhance their audio experience at home.