ProForm PFTL12008.0 Inset drawing. The connectors should slide, Ful not to pinch the wires

9. Slide the two Handrail Caps (80) onto the lower	9
ends of the Left Handrail (77) and the Right
Handrail (78) as shown.	5
Attach the Handrails (77, 78) to the Uprights (81,
83) with four 5/16" x 2 1/2" Patch Bolts (5), four	11
5/16" Star Washers (11), and two #8 x 3/4"	77		5
Screws (1).
Orient the Handrail Caps (80) as shown. Slide			11
the Handrail Caps against the Uprights (81, 83).	80	81
Firmly tighten the four 5/16" x 2 1/2" Patch Bolts			83
(5).		78
		1	80
			1

10. Have a second person hold the console assem-	10
bly near the Right Handrail (78). Connect the		Console
Wire Harness (84) to the console wire. See the
inset drawing. The connectors should slide		Assembly
together easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN YOU TURN ON THE POWER.
Next, remove the wire tie from the Wire Harness.
Insert the connectors and the excess wire into				Console
the Right Handrail.		78	84
Set the console assembly on the Right Handrail				Wire	Console
(78) and the Left Handrail (not shown). Be care-				Wire Tie
ful not to pinch the wires.					Wire
					84

10