Assembly

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the following tools: the included allen wrench, your phillips screwdriver ,

adjustable wrench , rubber mallet , and pliers .

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M10 Nylon	M8 Nylon	M8 Split	Spacer	M8 Washer (81)Ð6
Locknut (26)Ð7	Locknut (80)Ð2	Washer (58)Ð2	(44)Ð4	M8 Washer (81)Ð6
						Nylon Washer
	M8 x 108mm Bolt (79)Ð2						(11)Ð2
	M8 x 108mm Bolt (79)Ð2
	M10 x105mm Carriage Bolt (27)Ð2				M10 Split	Axle Screw (30)Ð2
	M10 x105mm Carriage Bolt (27)Ð2			Washer (93)Ð4		Axle Screw (30)Ð2
	M10 x 85mm Bolt (25)Ð1		M4 x 16mm		Console Plate		M4 x 16mm
			M4 x 16mm		Console Plate		Flange Screw
			Screw (35)Ð9		Screw (92)Ð4		(43)Ñ6

1. Hold the Rear Stabilizer (65) against the saddle on the

rear of the Frame (1). Make sure that the Stabilizer is

turned so the square holes are facing away from the

Frame. Attach the Stabilizer with two M10 x 105mm

Carriage Bolts (27) and two M10 Nylon Locknuts (26).

126

2. Turn the Resistance Control (57) counterclockwise to

the minimum setting.

If the Resistance Control (57) is attached to the Upright

(2), remove the M4 x 16mm Screw (35). Pull the bot-

tom of the Resistance Control away from the Upright

and then slide it down to remove it.

Tab

2 35