12.Attach the ground wire on the Upright Wire (28) to the indicated hole in the Base (48) with a #8 x 1/2" Ground Screw (27).
Press the indicated Grommet (86) into the Right Upright (36).
Raise the Right Upright (36) and the Left Upright (not shown).
13.Attach the Latch Housing (30) to the Left Upright (31) with two #8 x 3/4" Screws (2). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws.
Locate the Latch Pin Assembly (29). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (30), and tighten the knob back onto the pin.
12 |
| 28 | 36 |
48 | 86 | ||
|
|
| |
Hole |
|
|
|
Ground |
| 27 |
|
Wire |
|
| |
13 |
|
|
|
Knob | 30 | 31 |
| Large | |
2 |
| Hole |
| 29 | |
Spring |
| |
Collar | Pin |
|
|
|
14.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see page 21).
11